UNSOLVED

jgonera

updated

14 years ago

J

jgonera

4 Posts

0

58076

June 17th, 2011 10:00

M4400 (and possibly E6500/E6400) fan doesn't stop (thermal table questions and suggestions)

Hi,

Lately, my laptop's fan never stops once it kicks in (which is more or less 15-20 after I turn on the laptop). Since the idle temperatures of my M4400 are not very high (CPU 42-44C, GPU 54-56C), I started investigating what is the reason for such behaviour.

After a lot of reading and discovering the Fn + Shift + 15324, Fn + R combinations which let me see the thermal tables and readings of all thermal sensors in M4400, I saw that the sensor that causes the fan to run constantly is SKIN (DIODE4). I don't have any idea where this sensor is located (or what it measures) but it seems its readings don't fluctuate much. Once it gets to 48-50C it stays like that all the time.

In almost all BIOS versions (at least the recent ones I tested) the thermal table is configured in such way that the temperature of 48C of this sensor triggers the lowest fan level and to get the fan to stop again this sensor needs to get as low as 44C, which never occurs (at least with ambient temperature of 30C). All other sensors (CPU, GPU, DIMM) are in their lowest (i.e. fan disabled) ranges, only SKIN (DIODE4) causes the fan to run.

My question is: is this really necessary? Couldn't Dell change the thermal table of this sensor so that the fan stops from time to time? I guess triggering the fan at 50-52C and turning it off at 48-49C would be a better option.

Also (or alternatively), wouldn't it be possible to make the lowest fan level a bit slower? Now it's 3100RPM and it's noticeable. From my experience 2500RPM is already virtually silent (as quiet as my HDD), but if it's not enough, 2700-2800 should also be OK.

 

Regards,

Juliusz Gonera

  • speedstep

    11 Legend

    •

    46969 Posts

    1072

    0

    Posted June 17th, 2011 10:00

    If the heatsinks are clogged with pet hair and dust bunnies then the cooling will have a hard time keeping the system cool.

  • jgonera

    4 Posts

    1072

    0

    Posted June 17th, 2011 10:00

    This is not the case. The heatsinks are clean. Temperatures are not too high, it's the SKIN (DIODE4) sensor that triggers the fan too early.

  • digi85

    9 Posts

    1072

    0

    Posted August 28th, 2012 09:00

    Juliusz did you find out the solution ? The same problem with my cousins E6400 when A/C is plugged in. 

  • digi85

    9 Posts

    1072

    0

    Posted September 3rd, 2012 03:00

    Does anyone have the schematic of E6400s motherboard ? I guess the sensor is located near a power phase .

    Juliusz which motherboard's version do you possess ?  JBL01 LA - 3803 Rev. 2.0 (A01) ?

  • digi85

    9 Posts

    1072

    0

    Posted September 4th, 2012 18:00

    According to the schematic


    Diode circuit DP4/DN4 is used for skin temp sensor( placed optimally between CPU, MCH, MEM)

    Still don't know where exactly the sensor is and why a fan is running constantly.