UNSOLVED

brew1

updated

21 years ago

Closed

B

brew1

2 Posts

0

39681

June 20th, 2005 14:00

Dual Monitors Problems with Latitude D610

I have a Latitude D610 with the D-dock Advanced Port Replicator and an external Dell monitor. Is there any way to set this up to where I can use a dual monitor set-up. I have tried going to the Display settings and clicking the extend desktop button, but it only shows a clone on the second monitor. I am running XP Professional if that helps.
  • andykvakk

    6 Posts

    568

    0

    Posted June 21st, 2005 12:00

    If you have the Intel Grahics card you can go to Control Panel and select Intel(R) GMA Driver for mobile. Select Extended desktop on the menu on the left. Then you will be able to use extended desktop.

     

    :-)

  • brew1

    2 Posts

    568

    0

    Posted June 21st, 2005 14:00

    Thanks, that did the trick.
  • groggrog

    2 Posts

    568

    0

    Posted July 5th, 2005 11:00

    How about with two external monitors?  This would be without the laptop monitor, using just the two VGA external monitors.  Any way to hook those up?

    Thanks
     
  • andykvakk

    6 Posts

    568

    0

    Posted July 6th, 2005 21:00

    I have connectet two Dell 1704FPV monitors to my laptop. I use a D-Port port replicator which contains one VGA connector and a DVI connector. 1704FPV supports VGA an DVI so i have connected one monitor to DVI and the other is connected to VGA port. Then use the Intel Control Panel aplet to control the output :-)

    Good luck, hope this helps!

    Anders

  • groggrog

    2 Posts

    568

    0

    Posted July 6th, 2005 23:00

    So in other words you're NOT using two VGA monitors?

     

    Greg.

  • andykvakk

    6 Posts

    568

    0

    Posted July 7th, 2005 09:00

    That is correct. One on VGA and one on DVI. This was the only solution I could think of when i looked at my port replicator.
  • Born2x

    4 Posts

    568

    0

    Posted October 20th, 2005 13:00

    OK...I am using the "one VGA and one DVI" dual monitor output.  What I am hoping to do is a triple display layout using the laptop display + DVI out + VGA out.  So far, only two of the three can be active.  Should I even be able to have s-video besides to have four at once?