UNSOLVED

kries

updated

19 years ago

Closed

K

kries

2 Posts

0

6314

December 2nd, 2007 06:00

d820 heat, cpu fan

Hi, I have a problem with my d820 (cor2duo 7300, nvs110, speedstep enabled). Under load (eg compiling) it gets hot quite fast (within a few minutes) and when it reaches ?95° centigrade it gradually scales down the frequency to 1000 and stays there till the core temp is down to 70. Then it quickly rises again, scales and cools down, rises again and so forth. I think this is a new problem (this d820 was bought in May, had a broken ram changed a month ago) I've noticed for the least 2 weeks or so. I have no clue what is causing this problem and wonder if it might be caused by the fan. I've installed i8k tool and get a -1 for the first fan. My question: does the d820 have 2 fans (inner outer) and one is not working or is the heat problem caused by something else. Thanks, kries
  • mauisunset

    127 Posts

    166

    0

    Posted December 4th, 2007 04:00

    According the D820 service manual, there appears to only one fan:
    http://support.dell.com/support/edocs/systems/latd820/en/sm/fan.htm#wp1084976

    I work on both Dells and Thinkpads at my company and I've noticed that the laptops with the Core2Duo processors have heat sinks that have very tightly spaced cooling fins that seem to very easily capture dust inside the unit, restricting air flow and hence causing the system to run hotter than it would normally.

    Since I work on laptops for a living, I don't have a problem taking the keyboard and stuff off and carefully blast the dust off the CPU fan and heat sink. If your system is under warranty, don't do it yourself. Even if the system is out of warranty, I'd recommend you find someone who has done this before. The hinge cover that has to be removed before the keyboard can be removed is probably the trickiest part and if you're not careful, you can break the small tabs that hold the hinge cover in place.

    Here is what I would do but a I assume NO responsibility for any consequences!

    NOTE: It's best to do this outside as the dust inside the laptop can be very nasty, and keep your face well away from the laptop while doing this to avoid getting a cloud of dust in your face!

    Remove AC power, peripherals, battery, and keyboard. With canned air (being careful to NOT tip the can so as to spray liquid out of the can!), use short blasts to blow dust and stuff out of the heat sink and fan. I usually blast the dust from the exterior of the laptop in towards the fan - there are 3 vents: one at the rear (I'd do that one first), one on the left side of the laptop, and one from the bottom. I hold the CPU fan gently to hold it in place while blasting the air from the exterior vents of the laptop. Then do it the opposite direction from the cpu fan side out towards the vents, and then repeat. You can manually spin the CPU fan to blast the dust off the blades.