UNSOLVED

Marjnal

updated

19 years ago

Closed

M

Marjnal

18 Posts

0

7658

July 25th, 2007 14:00

C400 Power Supply

Hello, I have a C400 that I am very happy with. It came with a PA-8 Family ADP-50FH/Output 20v-2.5 amp AC adapter. I purchased a new C400 extended life battery. It came with a PA-6 ADP-70EB/Output 20v-3.5 amp AC adapter for remote charging. The plugs for connection to the Laptop are the same. Can I use either one for my Laptop. I don't want to carry 2 when I travel! Regards, Al

Message Edited by Marjnal on 07-25-2007 10:28 AM

Message Edited by Marjnal on 07-25-2007 10:28 AM
  • REO51ST

    29 Posts

    141

    0

    Posted July 25th, 2007 15:00

    This applies to all laptops.
     
    My IBM is16V and 3.36A INPUT

    My AC adapter is 16V and 3.36 OUTPUT = 53W. 16x3.36=53

    I could use 16V and 4.5 OUTPUT = 72W. 16x4.5=72

    Your AC adapter’s output voltage should be the same as your laptops input voltage.

    The ac adapters output amps can be equal to or greater but not LESS.

    If my laptops input is 4.5 and I tried to use a 3.36 output ac adapter there would not be enough power to run the laptop. It might work for a while but I would advise against it.

     
    So both would work but I would use the 3.5 Amp the laptop will only use what it needs. With the added need to charge the extended life battery the 3.5 Amp is your best bet.
     
    Good luck.


    Message Edited by Reo51ST on 07-25-2007 11:15 AM

    Message Edited by Reo51ST on 07-25-2007 11:15 AM
  • Marjnal

    18 Posts

    141

    0

    Posted July 25th, 2007 16:00

    Thank you for explaining some of the requirements for using Adapters with Laptops. My electrical experience is turning on a switch!