
UNSOLVED
This is how I fixed my 630i fan issue
Symptoms: Fans are always at 100% when set at automatic, or 100% setting but actually running at 5% (5xx RPM), no LED Lights when first start the system.
Steps I did to fix it:
- First of all, I flashed the BIOS to the latest one 1.0.4
- You need to reset the Master I/O board, follow the steps from the service manual.
- After you move the reset jumper from 2-3 to 1-2 position, leave it there for now, this is very important.
- Just reconnect all the cables to the I/O board, you don't need to connect the card fan for now, so you don't need to reinstall the card fan cage since we'll need to move the jumper back to 2-3 position later
- Start up the system, go to Nvidia Control Panel, adjust the case LED light to something different and close the control panel. It will ask you whether to load the saved setting at Windows start up, just answer no.
- Then you will see a pop up message box saying ESA configuration has changed and device output will be different or something like that I don't remember exactly. Just click ok.
From now on, the automatic fan control should work. So just shut down the system, and move the I/O board reset jumper back to 2-3 position and reinstall card fan cage and reconnect the card fan cable.
I'm not sure whether this will fix some of the LED lighting issue people are having. But now I have my LED light back on when the system start up. I'm not dare to touch the light settings again =P
Well at least it fixed the LED and fan issues I had, but your mileage may vary. Good luck!!
DELL-Chris_M made a clearer instructions from here
Message Edited by Tincat on 04-26-2008 04:58 PM
Responses (3)
Solutions (0)

HuttFuzz
57 Posts
234
0
Posted April 26th, 2008 16:00
Thanks dude, i didn't even know 1.04 was out...