
UNSOLVED
Replacement Fan
Need to buy a replacement fan for my PC. It't the fan that cools off the chip and it hooks onto the back of the PC and has a big green plastic deverter tyoe thing that's attached to it that deverts the aitflow to the heatsink attached to the chip. I have a DIM 4500 P4 2.4 Service tag is DCQ2Z11
Responses (10)
Solutions (0)
- Well I just bought this one, hopefully this will work ok.
- I am at the same point, but I cant remove the old fan. What holds it into that housing? Is the housing meant to come off the (grid) frame at the back or the fan meant to come out of the housing? It does not appear to be attached by screws at the corners......Thanks AllJohn
Message Edited by trainer45 on 03-06-2006 10:17 AM
Message Edited by trainer45 on 03-06-2006 10:18 AM
shesagordie
12 Elder
•
46017 Posts
267
0
Posted March 6th, 2006 20:00
bbydump
If you install a non-Dell fan, then you will get a "Fan Failure" error message at every boot up. Dell uses a proprietary fan unit, plus a proprietary heatsink and retention bracket.Bev.Message Edited by shesagordie on 03-06-2006 04:13 PM
shesagordie
12 Elder
•
46017 Posts
267
0
Posted March 6th, 2006 20:00
trainer45See if the following post can help with installing a Dell replacement case/processor fan,It would help, when you post, to include the system model.Bev.Thanks Bev
I have a Dimension 8300. The fan shroud assembly is as you describe in the other thread (anchored to the back frame grid), but I cant get it to release. I have found the levers, but the tabs holding it to the frame just do not want to give up! How hard can they be forced?
And, you know .... I looked for that manual for quite a while on the site and could not find it.
Thanks for your help
John
- yeah, I bought a new motherboard as well so I don't think I'll get an error. Motherboard, fan and PSU pretty much have all went up on me, so I went to newegg and am getting even better replacements for under $120 total. Can't beat that... Only problem is I have to bend the motherboard holder plate a bit to fit the new board.Yeah, I see what you mean about taking that fan out of the black plastic housing. Looks like lillt rubber tips hold it in. You can probably just pull them out.
shesagordie
12 Elder
•
46017 Posts
267
0
Posted March 7th, 2006 03:00
trainer45John.All you can do, is just keep working on the shroud to free it. That may be the reason, that when you buy a Dell OEM fan, it includes a replacement shroud as part of the OEM package, like the example shown here,Bev.- It looks like from all those replacement parts your Dell's not going to be a Dell anymore. I hope they all work for you alright.And let us know how the outcome is, i for one am curious because i messed with all that stuff and the fan IS what cured my problem after 7 months of dinkering with it. Good luck.

ejn63
11 Legend
•
87469 Posts
•
321256 Points
267
0
Posted March 5th, 2006 16:00