UNSOLVED

Okl62

updated

22 years ago

O

Okl62

18 Posts

0

5666

August 26th, 2004 17:00

Power problem or what???

Hi,
I have two Dimention4600 Machines.
I use two different surge protectors.
Both PCs do the same thing:
After I shut down a PC I turn off the power on Surge protector to turn off the monitor (since Dell PCs don’t have power outlet for monitor it is plugged into Surge protector) I also do this because I want PC to be physically disconnected from power when it is off.
Next day I turn Surge protector power button and PC behaves as if it starts up: all LEDS on, all fan star running. It lasts for about 1 second then stops - all LEDs off, fan stops. Then PC waits until I press Power button on the CPU – then it boots.
Since both PCs do the same I don’t think it is a problem in hardware, Its not a software problem too because nothing is booted yet. If it designed like this – what is the purpose?
I do not like this behavior. Every time PC has two power shocks instead of one – when it actually is booted.
Is anybody having the same problem (if it is a problem) with Dim4600?
May be there is a way of getting around (I still want surge protector be off when PC is not in use)… maybe Hibernate mode will help?
Thank you.
  • DELL-Les

    2 Intern

    •

    641 Posts

    169

    0

    Posted August 26th, 2004 18:00

    Okl62,

    Thank you for using the Dell Community Forum.

    Go into the BIOS to the section for AC POWER RECOVERY. Look at the setting for this and check to see what it is set to. If you are going to boot the system at the time you should probably set it to ON so that when you turn on the surge protector the system will go ahead and boot.

  • Okl62

    18 Posts

    169

    0

    Posted August 27th, 2004 14:00

    I'm not yet good with BIOS settings so I'm not sure if I did exactly what you told me to do.
    I tested with all possible combinations of Power Management options:
    Suspend Mode (S1 - S3)
    AC Power Recovery (On - Off)
    Low Power Mode (Disabled - Enabled)

    I tested with all possible combinations and still after I turn power on surge protector button on CPU should be pressed in order to boot. May be I have to upgrade BIOS...

    Thank you