UNSOLVED

tvmccorm

updated

16 years ago

T

tvmccorm

2 Posts

0

6672

November 10th, 2010 08:00

No memory modules are detected

I tried to upgrade my GX280 memory replacing my 4 256mb chips with 2 1 gig chips placed in the white DIMM1 & DIMM2 slots. I got the 1 3 2 beep code and the green A yellow B C D lights. Replacing the original chip singley or in pairs still gives me the same error mentioned in the subject.  Any suggestions?

 

Tom

  • Parthros

    1 Rookie

    •

    63 Posts

    627

    0

    Posted November 10th, 2010 10:00

    Well, did you check the maximum amount of memory each slot could hold?  They might max out at 512 MB.  Also, if they DO each hold 1GB, did you check the speeds?  If the speeds are not supported, you could get a beep code.

    One last thing to note, when you're getting new memory, make sure both modules are the same amount (in GB/MB) and are the same speed (in MHz).  The most important of the two to match is the speed.

  • btc64

    141 Posts

    627

    0

    Posted November 10th, 2010 17:00

    Same thing happened on my Precision 470 recently except I wasn't doing any swap of RAM. PC just "died". Sadly, I needed a new mobo to resolve the problem. The fact you can't use your old RAM suggests the same.

    Sorry to be the bearer of bad news. I tried everything to get my PC running again and only a new mobo solved it.

  • tvmccorm

    2 Posts

    627

    0

    Posted November 10th, 2010 18:00

    That's what I was afraid of.