
UNSOLVED
BB
Bill Bradley
232 Posts
0
272256
February 12th, 2008 08:00
Getting into the boot/BIOS screen of the Optiplex 755 with Intel VPro
I've been able to use IE to see the hardware information on the VPro chipset of the 755, but, haven't been able to figure out how to get into the Boot/BIOS screen.
I need to get in to remotely set these up to boot to PXE so that they can be Ghosted.
What's the trick to doing this? The manual mentions it can be done, but, doesn't give instructions on how to do so.
Thanks!
Responses (2)
Solutions (0)
in addition to enabling PXE via the BIOS screens - using vPro with a supported mgmt console will allow you to override the BIOS boot order and force a PXE boot. This is called "IDE-Redirection" with Intel vPro - and has been done with mgmt consoles such as SMS, SCCM, HP OpenView with Out-of-Band Manager, Altiris, LANDesk, etc.
To understand the features\capabilities of vPro - http://www.intel.com/technology/vpro/index.htm. Check out the online demo...
To understand more how to activate - there are series of great articles within this community (Altiris Juice), along with a more general step through at http://communities.intel.com/docs/DOC-1466

Jesse L (retired)
10 Wizard
•
17898 Posts
•
69016 Points
6992
0
Posted February 13th, 2008 13:00
Thank you for using the Dell Community Forum.
Keystroke Function
F2 Enter System Setup
Use to enter System Setup to make changes to the user-definable settings.
Network Boot Keystroke
F3 Keystroke Function
Bypass the BIOS boot sequence and boot directly to the network
Bypass the BIOS boot sequence and boot directly to the network by pressing during the POST sequence. Of course, for the boot to work, the network must be properly configured to support the network boot.
Integrated Nic:
This field enables and disables the integrated network interface controller (NIC). The settings are as follows:
Off — Integrated NIC is disabled.
On — Integrated NIC is enabled.
On w/ PXE — Integrated NIC is on (with PXE enabled).
NOTE:
PXE is needed only if you intend to boot to an operating system located on a server, not if you are booting to an OS located on a hard drive in this system.
The system can be turned on remotely from the Suspend, Hibernate, or off states.
When Low Power mode (located in the Power Management Group) is on, the system can only be powered up from Suspend. If remote wake-up from Hibernate or off is also required, Low Power mode must be set to Off.
Off — NIC cannot wake up the system.
On — NIC can wake up the system.
On w/ Boot to NIC — NIC can wake up the system, and the system boots from the network.
Jesse L (retired)