UNSOLVED

cwenger05

updated

22 years ago

C

cwenger05

3 Posts

0

16272

October 22nd, 2004 13:00

Dimension 8400 fans making odd periodic noises

A few times a day, the fan(s) on my Dimension 8400 will go into an odd cycle. With a period of about five to eight seconds, they will sound normal, then make a moderately-high pitched hum for a second, then go back to normal. This usually lasts about 15 minutes. I especially notice this at night when everything is quiet. Is this normal, or can anybody else confirm hearing the same type of noises from their fans? I have heard a lot about the new Pentium 4's running very hot, so I am a little concerned.
  • AZtoSD

    362 Posts

    276

    0

    Posted October 22nd, 2004 14:00

    When temps get above a certain level, the CPU fan will kick into higher RPMs.  The only time I've heard this was when I tested my fan using Dell Diags just to see what it would sound like.  But I also don't leave my system on all the time, which I'm assuming you do from your post, so maybe you're getting more heat build-up.

    Everyone's situation is a little different--ambient room temp, airflow around the case, etc.  Few suggestions: 1) Run the Dell diags and run the fan test to make sure the sound you're hearing is simply the fan going into overdrive and not a mechanical problem with the fan itself.  2) Make sure you have good clearance for airflow in front and back of the case, especially in the back (like if you have it in a desk cabinet or right against a wall.  3) Leave the flap on the front of the case up when the computer is on.

  • cwenger05

    3 Posts

    276

    0

    Posted October 22nd, 2004 14:00

    I'm sure the hum I'm hearing is due to the fans going to a higher RPM because the temperature got too high. My question is, why would it cycle between high RPM and low RPM on the order of seconds? If it was constantly high or constantly low I wouldn't mind, but the periodic hum bothers me.
  • rdaxx

    117 Posts

    276

    0

    Posted October 22nd, 2004 17:00

    At idle and even at low temps (35c) my fans change speeds. Nothing bad, but in a quiet room I can tell the difference in the sound. If your fan was really speeding up for a heat problem you would know it.

    I wouldn't worry about it.
  • AZtoSD

    362 Posts

    276

    0

    Posted October 22nd, 2004 17:00

    Again, hard to say.  But when you say you wouldn't mind if it was constantly on high makes me think maybe you should do the fan test.  When I did (I also have an 8400) it sounded like a turbine engine and it would drive me nuts to hear that all the time--kind of like having a vacuum cleaner running. 

    Try running the test just to make sure what you're hearing is the extra RPMs.  If the noise is the same, it is the fan kicking into high gear and you can attack it as a heat issue.  If the noise is different, then it might be a faulty fan.  

  • MugWamp

    1 Rookie

    •

    73 Posts

    276

    0

    Posted October 23rd, 2004 00:00

    A fan motor is made up of many, seperately manufactured components, assembled together and expected to operate smoothly with one another. This is not always the case, possibly due to tolerances used. Many motors require a 'break-in' period, while they adjust to each component that works in conjunction with one another. When I first turned on my 8400, I noticed the same thing: small increases/decreases in sound/rpms. Today, I hear those fluctuations much less. I'm sure than given a little more time, it will continue to wear down the imperfections and operate more smoothly..just like car engines, outboard motors etc.

    mugwamp

  • Moloko

    35 Posts

    276

    0

    Posted October 23rd, 2004 11:00

    Mugwamp,that is correct.My dimension 8400 is also stiller then two weeks ago.
  • 276

    0

    Posted October 25th, 2004 12:00

    I have the same noise on my 8400. It goes up and down, especially when the PC is under full load (Doom3, Video encoding).

    If I´m only at the internet, this sound will not happen.

    I think when the processor is hot, the system will do some kind of "more controlling" of the fan RPM.

    Maybe this issue can be solved by a bios update during the next month.

    If not, the other collegues maybe correct, that this phenomena will disappear after some "burn-in" time of the fan bearings.

     

     

     

     

  • solifer68

    7 Posts

    276

    0

    Posted November 17th, 2004 19:00

    Hi , just wonder do you have a dell 8400??  because you now cpu temp, i would like to now mine , have  a dell 8400 3.6?
  • cwenger05

    3 Posts

    276

    0

    Posted November 17th, 2004 19:00

    Solifer68, how do you know your CPU temperature? New BIOS version maybe? I have a 8400 with a 3.2 GHz processor.
  • solifer68

    7 Posts

    75

    0

    Posted November 21st, 2004 15:00

    I have 8400 with intel prescott 560 3.6 ghz i have the newest bios , but it does not contain any info on cpu temp, talked to dell but you dont get the help you want;-(