UNSOLVED

CP_no12

updated

21 years ago

C

CP_no12

4 Posts

0

4616

February 2nd, 2006 04:00

Dimension 4700 Locks Up - Need Help!

I'm hoping the folks on this forum can help.
 
I am having a problem with my Dell locking up randomly. It does it with various programs, so I can't pinpoint the culprit.
 
The system: I have a dimension 4700, 3 GHz, 512 mb, 140 GB hard drive. It is stock from the factory, except that I put in a Belkin FireWire PCI card. At one point, I did install a PNY 64mb video card, but have since removed it as I thought it was causing problems with one of the games I was playing. After removing the card, I unistalled the software for this card using add/remove programs.
 
I first noticed the problem a few months back. The computer seemed to be lagging a bit and would occasionally lock up. But, back then, it was only once every couple of weeks. So I thought no big deal. No computer is problem free. But the lock-ups got more and more frequent. Then I noticed that it seems like my hard drive was constantly starting and stopping. The light is constantly flashing even when I'm just working in a spread sheet or word processing program.
 
The system locks on various programs: Word, Excel, AutoCad, games, video editing software, Norton scan.
 
Once the lock-ups got to be as frequent as at least once, I decided to install Norton System Doctor to see if that could diagnose the problem. At first, I couldn't even get Norton to do a full system scan without locking. Then I ran through the windoctor check and cleaned up a few hundred errors. At some poini, I was able to detecet and remove an adware program. Finally I got Norton to do a full system scan. No virus found.
 
I ran Dell Diagnostics (F12 at bootup) and the only errors found were something to do with sound error codes 1B22:0f13 and 1B22:101B. I don't think this is the cause. I've tried the Windows memory testor and it found no problems. I ran the Window crash diagnistic program and no problems found.
 
I don't know what else to check to find the problem.
 
I have some ideas of possible causes, but not sure if any could be it:
 
1) Do I need more memory to run Norton plus all the other junk in the background, plus the main programs?
2) I have an HP all-in one connected via USB. I've heard that these can cause problems.
3) I recently installed Quickbooks SImple Start (I saw this software pop up on other posts to the forum).
4) There's just too much stuff running in the background (around 50 processes running).
5) I am running MS Office 97, but Word and Works 2000 came with the computer and are still installed.
 
Any ideas on what to check next? Or who the culprit could be?
 
Your help is greatly appreciated!!
 
  • ricolit

    66 Posts

    94

    0

    Posted February 2nd, 2006 21:00

    had same problem, turned out faulty hdd (cause is still a mystery, could be power)
    had three hd failures on new dim 8400 in 5 months. dell replaced hdd, motherboard and software on 5 occasions.stll left with a very slow system (write speed to hdd of 0.42MB/S!!!!!!. when using the dell diagnostics all test past!!, but one thing is not benchmarked that is the speed (time) the test takes. clock the time it takes for the drive to test (if you have more than one it is easy to compare) i noticed one drive 0 a confidence test timeing of around 100 seconds. on drive 1 it took 17 minutes! both are identical drives. so logically they shuold take about the same time. when using raid(0) you end up in a right dell of a mess with that speed difference
    i phoned dell and spoke to a very clever, polite and knowledgable bloke (indian) who understood what i was saying (and i have a fair dutch accent myself) took immediat action, talked to his manager and sorted me out once and for all. they sending me a brand new 9150 system.(with a load of soft and hardware updates.
    my advise: ALWAYS use dell (or other diagnostics) when you first get your new pc and TIME it (especially hdd, cpu mem cd/dvd drive) then if you think you might have a problem (sluggish low performance), clean and defrag, remove spy and bloatware, reboot and run dell diagnostics again and TIME it. a difference of -20% should be acceptable(as i 've been told) Good luck and dispite all i hear, a couple of hunderts tech support people, over 8 million pc's, my problems correctly solved (maybe not straight away, but hey were talking pc and microsoft here)  i will always recommend dell support.
  • CP_no12

    4 Posts

    94

    0

    Posted February 3rd, 2006 03:00

    Thanks for the response. Any ideas how to diagnose or detect a bad hard drive? My Dell warranty just ended, so having the HD replaced is going to cost quite a bit. I would like to be sure that is really the problem before doing that.
     
    The dell diagnostic did take quite a while to run, but I thought that it was because I ran the full set of tests.
     
     
  • ricolit

    66 Posts

    94

    0

    Posted February 3rd, 2006 09:00

    if you run the dell diagnistics, choose custom test>hardrive>confidence test.  this should run at around 1% per second. if this takes far longer, the change of having a failed drive is very big. you might then contact the manufacturor and explaine. i know that western digital (for a WD drive) has the possibility to sent the drive to them for an assesement. if it is a non-standart defect they might exchange it.
     
    its very funny that no diagnostics tool times itself  to see if it runs to slow.
     
    you also might benchmark your drive. use fresh diagnose (is free), just register and they sent you a key. FreshDevices.com