UNSOLVED

missy1301

updated

14 years ago

M

missy1301

2 Posts

0

5446

March 3rd, 2013 17:00

Dell Desk top XPS 400 will not come on

I have a dell desk top xps 400 that i went to use yesterday and it was dead! The light on the monitor is orange and their is a green light on when I look into the back of the computer. This light even stays on a little bit even after unplugging the computer?!?  I know nothing about computers.....absolutely nothing! I did pull the front off and blow the dust out and undone all the cords form the back. I plugged everything back in (even in different outlets that I know work) and still nothing. No clicks, sounds or fan trying to run nothing. Could anyone give me an idea of what to do next? I've read something about power supply and motherboards from this forum but have no clue as to what that is. I thought the power supply that everyone was referring to was a new power cable but was surprised when i pulled it up and it is a big box with cords coming out  it. If thats the next step...can i do it or should i take a trip to the repair shop?

  • 178

    0

    Posted March 3rd, 2013 18:00

    Hi missy1301,

    It appears to be a hardware issues. You can release the static power by performing the following steps:

    • Remove all external peripherals (Printer, Camera etc.) connected to the computer.
    • Press and hold the power button located at the front side of the tower for 10 seconds.

    Then turn the system on and check the status of the power button LED located at the front side of the tower. Also check the status of ‘Diagnostic lights’ numbered 1, 2, 3, 4 located at the front side of the tower under the hard drive bay(Shown in the picture below). This may help us isolate the issue. In case you hear any beeps, please note down the pattern and share the same.

    Image - Diagram illustrates the front of the chassis.

    Number 10 in the above picture is 'Diagnostic Indicator' (1,2,3,4). Number 8 is the power button.
    Would also suggest you to swap the power cable of the Monitor with that of the system tower and see if that works.
    Please share the findings.