
UNSOLVED
T
TheVince812
6 Posts
0
133307
February 19th, 2005 18:00
Amount of system memory has changed
Is there ANY way to make this message go away?
Amount of system memory has changed, strike F1 to continue, F2 to run the setup utility
I have been replacing MoBo's on my fleet of sx270's, but I recently have been getting this error after the MotherBoard has been replaced. I run the setup utility, BIOS says the RAM is there and working, next reboot and everyone thereafter gives that same error. I flashed the BIOS from v.A05 to v.A06, and experience the same result. The RAM, CPU, Heatsink, Fan, HD, are all the same only the MoBo is different. I would like to get the error to stop, but if there was a way to turn off the error so it will continue to boot (W/O striking F1 or F2), that would make my life easier
Responses (15)
Solutions (0)
TheVince812
6 Posts
21094
0
Posted March 1st, 2005 15:00
I have not - I have been replacing the motherboards until the message goes away - sometimes it does, sometimes it doesn't. (Sometimes it takes two or three tries). I was excited to see a post on this - I thought that someone might have solved the problem....darkstar2004
2 Posts
21094
0
Posted March 2nd, 2005 11:00
After seeing the message, have you tried rebooting, going into BIOS (you mentioned it was correct there) and then saving the BIOS settings to store the new RAM configuration? May be a simplistic question, but I didn't see it mentioned in your original post.Message Edited by darkstar2004 on 03-02-2005 07:39 AM
- Yes, I have rebooted and gone into the BIOS and checked the memory amount, which is ok, however when I exit it never asks to save changes. And I wouldn't expect it to because I haven't made any changes. I'm sure I've seen times when no changes were made to a BIOS and it still asks to save changes however this PC doesn't.
TheVince812
6 Posts
21094
0
Posted March 2nd, 2005 17:00
yes, like DebKing I have tried to verify and save the amount of RAM the system finds. I have even gone as far as to make a change and save the changes, but the memory error still appears at boot.- This is similar to the ESM log generated by servers. It stores error messages. Say it is a fan or power supply issue and the parts are replaced the ESM log or in this case the event log can continue to report it as a problem until the ESM log is cleared.
TheVince812
6 Posts
21114
0
Posted March 3rd, 2005 15:00
I tried the FIX, cleared the error log, current event log status: valid (in blue) saved changes, reboot - error : the amount of system memory has changed, strike F1 key to continue, F2 to run the setup utility I have been trying ever since I read the post, still having the same trouble. I was counting on this to work. Thanks for the info, I'll keep searching for answersTheVince812
6 Posts
21114
0
Posted March 3rd, 2005 16:00
ah-ha - I have made a discovery! I have turned off the report keyboard errors and turned off fast boot and now the system will continue to boot w/o user input (F1 or F2) although the error still shows, there is no beep and no user input required, system continues to OS.

DebKing
2 Posts
21094
0
Posted March 1st, 2005 15:00