
UNSOLVED
Closed
L
LowEndLaptop
1 Rookie
•
20 Posts
0
594
March 28th, 2018 10:00
Inspiron 7737: Flickering USB port now causes audible electrical noise and inmediate shutdown.
My laptop has always had a flickering USB port. First, I thought it was the device I connected to it but much later I realised it was the port itself. Everything that is connected to such USB port is loose and has an unstable connection that drops with the slightest touch. Recently I have started to have random full system shutdowns. I thought it was because of some driver but then I realised a cause-effect relation between the use of such USB port and the shutdowns. If I slightly touch whatever is connected to such port I can hear electrical noise followed by a full system shutdown. Sadly, the affected USB port is the PowerShare one (soldered to the motherboard) and the laptop is out of warranty I know it was my fault not to realise the issue while I was within warranty but is there any affordable fix other than not using the port at all?
This conversation is no longer open for comments or replies and is no longer visible to community members.
Responses (5)
Solutions (0)
LowEndLaptop
1 Rookie
•
20 Posts
512
0
Posted April 1st, 2018 10:00
To be more precise the looseness takes place between the USB male connector and the female one and not the USB and the motherboard. In fact, I bended back the side tabs of the USB female connector long ago and temporarily fixed the issue but due to the bend stress it came back.
Side tabs
Would it be possible for you to share the specifications of the USB female connector, so I can buy a replacement and solder it?
I do not think it is a very eco-friendly solution to trash the whole motherboard because a single USB port is loose.
Robert P (retired)
6 Operator
•
9396 Posts
493
0
Posted April 2nd, 2018 07:00
Unfortunately, the specifications ie: pin outs of the USB port are not available.
Robert P (retired)LowEndLaptop
1 Rookie
•
20 Posts
477
0
Posted April 5th, 2018 05:00
I really hope you do not trash motherboards in this repairable condition internally as it would be a huge e-trash generator.
LowEndLaptop
1 Rookie
•
20 Posts
451
0
Posted May 27th, 2018 08:00
Upon further investigation and with the help of a polimeter I have discovered that the PoweShare USB port is in fact different from the rest. It uses both the GND and the shield GND pins as a switch to detect whether a device is plugged in or not by adding an extra non-standard internal pin that is prone to bend easily and makes the whole thing non-standard compliant. For this single reason this USB port is prone to loose contact with the GND pin resulting in no power flow. Thank you for making such a poor design choice. As of this I only had three real USB ports and one non-compliant pseudo-USB port while the device was marketed as having four standard USB ports.

Robert P (retired)
6 Operator
•
9396 Posts
526
0
Posted March 29th, 2018 06:00
Hi LowEndLaptop,
Thanks for posting. Apologies that your system is not performing as expected.
Unfortunately it sounds like an electrical connection between the USB port and the motherboard failed, and continued use of the port is now causing the motherboard to fail. Without further troubleshooting, it would be difficult to say whether or not the whole motherboard would need replacement. If that's the case, then motherboards for this model cost around $200-$300. Some locations where parts may be available are: Dell Spare Parts, Parts-People.com, or Discount Electronics.
Robert P (retired)