How come my System Update tasks never show a status that has a check mark?
I have pushed out a few test System Update tasks. They end up bringing the servers up to date but I never see a result that shows a nice green check mark. They always look like they failed. How can this be avoided?
After the next inventory cycle runs, which may be a few minutes, the compliance report pie chart should reflect green to indicate the servers are now in compliance.
What screen are you looking at that you would expect to see a green checkmark? I may not be clear on your question.
I have the same problem, the firmware updates apply successfully (I manually ran a re-inventory) and the system is now "green" as compliant but the actual task "system update" just times out and eventually shows a red X
The Task waits for OMremote to respond and after a waiting for the OMremote it times out. The server might be in a reboot state or the update is being applied, basically OMremote is timing out. So the patch is working, but the task times out for some reason. You may look at the state of the target. I think this has been improved somewhat since the Nov Open Eval.
Is there anything obvious on your target (reboot req, etc.?)
I believe all of the boxes required reboots. That's not the point. They end up being fully patched but I have to dig through logs to verify versus the little indicator being a little more "reboot-aware" and showing that. +1 requesting the resiliency being improved to show proper status in future versions.
DELL-Rob C
4 Apprentice
•
2843 Posts
689
0
Posted January 25th, 2012 06:00
Hi,
After the next inventory cycle runs, which may be a few minutes, the compliance report pie chart should reflect green to indicate the servers are now in compliance.
What screen are you looking at that you would expect to see a green checkmark? I may not be clear on your question.
Thanks!
Rob