You should be able to just insert the port card and it should work. You do have to keep one key thing in mind though and that is port indices. You can read more about this in the EMC 3.1(2) release notes. Here are some highlights of from the release notes:
Port Indices: ◆ In a chassis with Supervisor-1, the port indices are limited to 256 irrespective of type of line cards. ◆ In a chassis with Supervisor-2 and a mix of line cards (Generation-1 & Generation-2), the port indices are limited to 256. ◆ There are some restrictions on index allocation for Generation-1 line cards (indices for ports in the same line card need to be contiguous, for example) which are not applicable for Generation-2 line cards.
The port index allocation scheme is modified in SAN-OS 3.0 to address the above limitations. The index allocation information can be displayed using the commands ¿show system internal index-allocation¿ and ¿show port internal info global¿.
Hi. Just reading through and the statement is correct about the port indexing. But on a MDS 9506, you will not need to worry. The indexing goes down to 252 ports when you mix Gen1 and Gen2 line cards but with the MDS 9506, you only have 4 available slots for line cards. So even if you fill all 4 slots with 48-ports, you will not reach the 252 limit.
Only thing I would make sure is that you are running SAN OS 3.x and higher b/c that's when the line card was supported. I think you stated you were running 3.1(2)...so you should be alright.
ConnectrixHelpe
259 Posts
329
0
Posted March 6th, 2008 07:00
Port Indices:
◆ In a chassis with Supervisor-1, the port indices are limited to 256 irrespective of type of line cards.
◆ In a chassis with Supervisor-2 and a mix of line cards
(Generation-1 & Generation-2), the port indices are limited to 256.
◆ There are some restrictions on index allocation for Generation-1 line cards (indices for ports in the same line card need to be contiguous, for example) which are not applicable for Generation-2 line cards.
The port index allocation scheme is modified in SAN-OS 3.0 to address the above limitations. The index allocation information can be displayed using the commands ¿show system internal index-allocation¿ and ¿show port internal info global¿.