i need to upgrade my 9513 and 9222i to 5.2.6a from 4.2.7d. As i am looking at the release notes i will first need to upgrade to 5.0.8 and then to 5.2.6a.
One caveat that i see is that we currently use IVR without IVR-NAT and this configuration is no longer supported in 5.2.x. Release notes provide the commands to migrate to IVR-NAT mode that seem to be relatively simple. I understand that this will require an outage.
Has anyone done this recently, any pitfalls ? Did your IVR topology, zones stay intact ?
sorry but you are in the same boat as i am, have to schedule an outage to convert to IVR-NAT before you upgrade to 5.2.x . I am working with my customer on scheduling a good time (obviously will do one fabric at a time), when did you plan on upgrading ?
We're still planning, but we're now evaluating the risks. Will it really only be a short disruption without any reconfiguration or do we need to reconfigure zones after IVR NAT is enabled?
I found these steps:
If you are using IVR non-NAT mode, migrate to IVR-NAT mode before you upgrade to NX-OS
Release 5.2(1). IVR non-NAT mode is deprecated in NX-OS Release 5.2(1).
Note In dual SAN fabrics, IVR traffic can use one fabric while the other fabric is migrating. Only
IVR traffic is disrupted during the migration. Regular traffic within the VSAN is not
disrupted during the migration.
To migrate to IVR-NAT mode, follow these steps:
1. Stop or divert all applications on servers that depend on IVR.
– If CFS distribution is not enabled for IVR, then perform steps 2 through 4 on all switches where IVR is enabled.
– If CFS distribution is enabled for IVR, then enter the ivr commit command following step 2, step 3, and step 4 to distribute the changes to other switches.
2. Deactivate the IVR zone set by entering the no ivr zoneset activate command.
3. Enable IVR NAT by entering the ivr nat command.
4. Activate the IVR zone set by entering the ivr zoneset activate command.
5. Start or reestablish all application that were stopped in step 1.
RRR
6 Operator
•
5739 Posts
574
0
Posted January 4th, 2013 05:00
Interesting question you've got there, Mr D!
In what version is IVR NAT not supported anymore?
We're already running on 5.0(4) and we're going to 5.2(6a/8), so we might have the same issue then.....