UNSOLVED

DanT2

updated

18 years ago

D

DanT2

1 Rookie

•

100 Posts

0

1509

May 27th, 2008 14:00

Metalun on solaris

I expanded a LUN fine using Navisphere. I dont see the added capacity on the servers side though. This is on cx-500 and server is solaris 9. I did run 'devfsadm' but still dont see added disk space. What am I missing?

Thank you in advance.
  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    467

    0

    Posted May 27th, 2008 14:00

  • DanT2

    1 Rookie

    •

    100 Posts

    467

    0

    Posted May 27th, 2008 14:00

    Dynamo:

    That did not help. I still can't see the 30+ GB I added. And the metalun status shows as normal.

    Thanks

    Message was edited by:
    atemc
  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    467

    0

    Posted May 27th, 2008 19:00

    are you using Veritas ?
  • Kiran3

    410 Posts

    467

    0

    Posted May 27th, 2008 21:00

    go to format and apply label to expanded disk...do this 2-3 times and then the server should be able to see the added capacity...

    this can be done online...
  • DanT2

    1 Rookie

    •

    100 Posts

    467

    0

    Posted May 28th, 2008 07:00

    No, I am not using veritas.
  • DanT2

    1 Rookie

    •

    100 Posts

    467

    0

    Posted May 28th, 2008 09:00

    Now I see the partition being bigger with the new added space but when I try to label the disk, I get:

    partition> label
    Ready to label disk, continue? y

    Warning: error writing VTOC.
    Label failed.
    partition>

    I unmounted it before I did this , I still get the same error.
  • ovivier

    142 Posts

    467

    0

    Posted May 29th, 2008 07:00

    Check in the metalun properties if current capacity = maximum capacity.
  • DanT2

    1 Rookie

    •

    100 Posts

    467

    0

    Posted May 29th, 2008 14:00

    Yes, it is set to 'max'.
  • malikd1

    24 Posts

    467

    0

    Posted June 13th, 2008 08:00

    try following steps, if it helps

    1. unmount filesystem
    2. stop vol using volume manager
    2. disable disk group using volume manager.
    3. run devfsadm.
    4. check for additional space on LUN.
    5. enable diskgroup.
    6. start volumes.
    7. run fsck
    8. mount filesystem.