I put a R7 board in NZXT phantom 530 (white case).
the R7 chassis barebone without AW plastic skin and top vent is shockingly small oem metal case with imo poorly designed metal swing arm used in multiple models of that time (R5-R12, XPS8910-30). When asked if I would like to have the chassis I firmly passed it. The board was offered to me as compensation for a pc repair project and the original owner moved its 8700k+1080gtx to a different board. I got the R7 board with AIO and fans. I put in my i3-8100 from a broken HP pc and connected NZXT pwr cable to two pins of R7 led header and reset cable to clear cmos pins (iirc). I recall each time pc is turned off I had to clear cmos by pressing reset then press power button to turn on pc. A quirk of swapping R7 in non Dell case. It must not like the two pin power switch set up and can only accept one power on action each time, requiring a reset to do it again. That was my hunch.
@ProfessorW00d I am 3D printing a few parts as we speak. I found a X tower to house my radators I think I am on a awsome pace with your tips and Ideas. So appreciated in so many ways!!
redxps630
11 Legend
•
16431 Posts
•
83176 Points
0
2
Posted January 1st, 2026 12:34
I put a R7 board in NZXT phantom 530 (white case).
the R7 chassis barebone without AW plastic skin and top vent is shockingly small oem metal case with imo poorly designed metal swing arm used in multiple models of that time (R5-R12, XPS8910-30). When asked if I would like to have the chassis I firmly passed it.
The board was offered to me as compensation for a pc repair project and the original owner moved its 8700k+1080gtx to a different board. I got the R7 board with AIO and fans. I put in my i3-8100 from a broken HP pc and connected NZXT pwr cable to two pins of R7 led header and reset cable to clear cmos pins (iirc). I recall each time pc is turned off I had to clear cmos by pressing reset then press power button to turn on pc. A quirk of swapping R7 in non Dell case. It must not like the two pin power switch set up and can only accept one power on action each time, requiring a reset to do it again. That was my hunch.
(edited)