Hi, last night I installed my 970 Evo Plus 1tb ssd into my computer, cloned everything on my hard drive to my ssd and then cleaned my hard drive to use for storage. I now can no longer boot my pc, my ssd doesn't show up in my boot options and everytime I try to boot, it says I need to repair my computer. I'm not sure what to do because the only options in the boot settings are Onboard NIC 1v6 and 1v4. I really need some help.
First try disconnecting all other drives, and try to boot again with just the new drive connected.
If that does not work: If you have the installation media, press F1 at that menu to initiate recovery.
When you cloned it, how did you clone it?
Although it is a bit late for this now, but as a general rule of thumb you should never wipe an original dive until you are sure the new setup boots up and works properly.
I cloned it using Macrium Reflect, and I thought it was working but apparently it wasnt. I havent tested it with the installation media but will update you when I do. (Should I replugin the HDD when using the installation media or keep it un-pluged. I dont want to lose my stuff, but if I have to that is fine.)
All you would need plugged in is the new drive, and insert the USB installation media for recovery options. The Windows installer should detect the SSD and have the option to repair the installation.
If you have a bootable Macrium Reflect environment, I would suggest you make a backup of the new disk that has your data on it prior to doing any type of recovery process. Normally with disk imaging software you would have created a bootable USB that can be used as a cloning option in a pre-boot environment.
Please do not post your private Service Tag in public. Click the blue DELL-Cares username. Their profile page will appear. On the right click, "Send this user a private message". They will need the private PC Service Tag to check your purchased warranty status, components, etc.
The installation media should be a bootable USB, and you should be able to boot directly from it using the one time boot menu (F12 key) at the Alienware logo screen.
From there the installer should be able to detect the installation and have a repair function.
Since you wiped the original drive already, you also wiped out the recovery environment it contains to reinstall your PC to it's factory state.
You will have to make sure you have the bootable Windows USB installation media as you will need that to try and repair the cloned version.
Vanadiel
8 Professor
•
7094 Posts
•
29695 Points
956
0
Posted January 11th, 2022 08:00
Try pressing F12 key at boot time to access the one time boot menu, and see if it lists the new drive as a boot drive.