OK, now I understand. Print quailty and imaging issues can be very subjective. I completeIy misunderstood your initial post. I though that just one of the colors was mis-registered. I'll need to give a friend of mine a call about this. I'll try to re-post here within the next couple of days.

I just re-read your initial post...... I must be tired tonight. Don't know how I misread it so bad. Sorry.

Will get back to you on this.....

Sure I could.  And though I appreciate the offer to help, I don't understand what use the cropped section of the test page could be.  The output color registration relative to each of the others is fine.  It's the output as a whole that has shifted 1/16 to 1/8" to the left on the media rather than any one color or any subset of the printed output.  For example, if you just printed a page consisting of a black frame that ran the perimiter page at the margins, instead of a consistent 1/2" (or whatever your margins may happen to be) around all four sides, the left side of the frame would be 3/8" from the left edge of the page and 5/8" from the right edge.

 

Nevertheless, if you believe the test page would be helpful, please confirm and I'll gratefully post it.

 

Thanks in advance for your assistance.

I'd be grateful for any insight you may lend to a solution.

 

Thank you again in advance.

Could you print the built-in color test page and examine the pie chart area? If you can scan this page, crop-out and copy the pie chart section and insert this image with your reply, I might be able to give you some adjustment guidance.