UNSOLVED

magoerlich

updated

4 years ago

M

magoerlich

1 Message

0

378

December 16th, 2022 17:00

DDM 2.0 Remote Management and Control for IT managers

Hello there,

What is Dell Display Manager (Remote Management and Control (for IT managers only)

Could I please have that documentation about the Remote Management capabilities mentioned there?

DDM 2.0 comes with CLI commands for querying asset inventory logs and to set basic monitor settings. CLI commands are restricted for IT managers only. Contact Dell sales representative for more information.

I don't know how I get a "IT-Manager" or if I'd want that actually, but what I want is to fully use the productive potential of my new U4320Q with some custom scripts that change my PBP configuration on-demand.

The possibilities the GUI offers aren't enough for that and I know that the CLI options have the possibility to change this settings. I already figured out some things according to some old and partly outdated post I found throughout these forums. But none of them seem to be accurate for the current release and it'd be nice to not figure everything out by trial-error.

Thanks, Manu

  • DELL-Chris M

    Community Manager

    •

    56891 Posts

    •

    232143 Points

    143

    0

    Posted December 17th, 2022 13:00

    All I have is this.

    DDM 2.0 CLI (command line interface)

    WriteActiveInput [DVI2/HDMI/DP2,etc] = switches active input
    ReadActiveInput [DVI2/HDMI/DP2,etc] = switches active input
    RestoreFactoryDefaults = restores factory defaults
    AutoSetup = executes an autosetup (analog only)
    ReadColorPreset = read the current color preset
    WriteColorPreset = set the color preset
    RestoreLevelDefaults = restores level defaults
    RestoreColorDefaults = restores color defaults
    WriteBrightnessLevel X = sets brightness to X% (0-100)
    ReadBrightnessLevel X = sets brightness to X% (0-100)
    WriteContrastLevel X = sets contrast to X% (0-100)
    ReadContrastLevel X = sets contrast to X% (0-100)
    WritePowerMode [on/off/standby] = sets the display power mode (standby should be used for central control.)
    WriteOptimalResolution = switches to optimal resolution
    WriteEALayout [X] = changes Easy Arrange grid type to X (0-48) where 0 is to turn off EA layout
    Rescan = rescans display hardware
    ReadControl X Y = sets hex control X to hex value Y
    WriteControl X Y = sets hex control X to hex value Y
    IncreaseControl X Y = increases the value of control X by Y
    DecreaseControl X Y = decreases the value of control X by Y
    WritePxP [Off/PiP/PBP Main Sub1] = Change PIP/PBP settings
    WriteSubInput [DP1, DP2, HDM1... etc}] = Change the subinput
    SwapVideo = Swaps the main (primary and sub inputs between 2 PCs
    SwapUSB = swaps the usb inputs on the main and sub inputs (for 2 PBP mode only)
    Zoom = switches between PxP and fullscreen mode
    Exit = terminates the program


    DELL-Chris M (old account)

    #IWork4Dell

  • lajackson

    1 Rookie

    •

    7 Posts

    62

    0

    Posted March 3rd, 2023 11:00

    Do you have any examples of how to use: WritePxP [Off/PiP/PBP Main Sub1] = Change PIP/PBP settings

    Specifically, I'm trying to configure PBP.