UNSOLVED

mayfab

updated

23 years ago

Closed

M

mayfab

3 Posts

0

6029

May 3rd, 2004 13:00

LCD or just the Inverter?

Hi,

I have an Inspiron 8200. The LCD is a SXGA with 1050 x 1400 resolution and the video card is ATI Radeon 9000 with 64 Mb RAM, 

In the past two weeks the LCD has not worked properly.

At the beginning columns of dead pixels appeared (I would say one column every three). The other pixels were turned on and regularly coloured.

Now I have the LCD mostly coloured of red and the dead columns are still there. Moreover some pixels are blinking and/or changing colour randomly.

I tested successfully the video card using an external CRT monitor. I am pretty sure that everything depends on the LCD hardware. But I have still a doubt.

Could this problem depends on the LCD inverter only? The LCD panel looks good. My opinion is that the circuit controlling the pixels is broken. The only I know is the Inverter.

Did anybody have a problem of this type? Do you think I have to replace the LCD or just the inverter?

Thank you in advance for your help.

Fabiano, Italy

  

  • mattcowger

    2582 Posts

    115

    0

    Posted May 3rd, 2004 13:00

    This isn't the inverter (which provides power to the backlight). Sounds like you have a bad connector somewhere - i'd tried to reseat your lex cable and see if that helps.
  • mayfab

    3 Posts

    115

    0

    Posted May 3rd, 2004 14:00

    Hi,

    I will try and I'll let you know.

    Thank you very much for your suggestion. ( I did not have any idea about what the inverter is!)

    Fabiano, Italy

  • jcsloan

    2 Posts

    115

    0

    Posted May 4th, 2004 19:00

    I experienced similar problems on my i8200.  I replaced the lcd, not the inverter, and the problem was fixed.  If you bend the screen by twisting the top edge on the front bezel do the lines come and go in different places?
  • mayfab

    3 Posts

    115

    0

    Posted May 5th, 2004 08:00

    Hi,

    the vertical black columns of dead pixels do not move. I tried to bend the panel in any possible way, but there is no correlation between the motion I apply and the defect I see.

    Sometimes the panel looks all red, sometimes there are red spots (distributed like in a leopard-skin coat) that travel randomly. It really seems to be an LCD problem.

    I checked all the connections (flat flex cable) and everything is OK.

    I took a picture of the display, but I can not post it in this forum (I do not have an URL).

    I am going to buy a used SXGA LCD. I hope this fix the problem.

    Thanks for your suggestion

    bye

    Fabiano, Italy