UNSOLVED

littlestick

updated

20 years ago

L

littlestick

2 Intern

•

133 Posts

0

17336

September 6th, 2006 00:00

8400 wont boot up

Hello, I have a problem for all you experts here. My wifes 8400 running XP has been working fine but now when you start it up it sits and beeps until you push the enter key, then finishes booting. Any help will be appreciated, thanks.
  • Bubba-G

    1 Message

    169

    0

    Posted September 6th, 2006 00:00

    those are post test beeps....means the computer thinks some part of the hardware isnt working or isnt working right....the number of beeps will give you a clue
  • littlestick

    2 Intern

    •

    133 Posts

    169

    0

    Posted September 6th, 2006 02:00

    Are you refering to how many beeps before a pause and then beeps again. As far as how long it will beep, haven't really tried that but it seems as though it will do it until you hit the enter key.
  • PETER345

    1 Rookie

    •

    5796 Posts

    169

    0

    Posted September 6th, 2006 07:00

    Are there any error message?

    Peter
  • Mary G

    6 Operator

    •

    20095 Posts

    169

    0

    Posted September 6th, 2006 14:00

    Open it up and look at the can shaped things on the motherboard. There is a defect on some 8400's that causes the capacitors to leak or bulge on the tops. If you see that contact Dell for a replacement motherboard--even if you are not under warranty.
  • shesagordie

    12 Elder

    •

    46017 Posts

    169

    0

    Posted September 6th, 2006 19:00

    littlestick
     
    What is the reading of the power button LED, green, blinking green, solid amber, blinking amber? 
     
    What is the sequence of the diagnostic LEDs at the back panel of the case?
     
     
    Bev.
  • Katonk

    10 Posts

    169

    0

    Posted September 29th, 2006 18:00


    @CaptRock wrote:
    I read EVERY message regarding the problem many have had/are having, with their 8400. I've tried EVERY remedy suggested by the those who chose to leave them (thanks!), but my problem continues. After pressing the power button, which shines a steady amber, the fan leading from the heat sink/blower assembly just accelerates like a "jet engine," as described by some posters.


    (1) First and foremost, I can't locate those four lights nearly everyone is referring to in their posts.


    (2) This steady amber power light is suppose to be an indication of a memory module problem (I have two 1GB DDR2 PC2 modules - slots 1&3) . As suggested, I removed/reinstalled the memory modules, then removed/reinstalled cards (PCI Express X16, modem). The problem remains.


    (3) I've detached/reattached HD, CDRW, DVD, and floppy drive. I've cleared the CMOS and reset NVRam. The problem remains.


    (4) The only "bright" point to all this is that the standby power light is illuminated. I take it that is a good thing.


    After all of this, it might be safe to say that my motherboard is shot! If anyone can be of any further assistance, please speak (type) up.







    Capt, you following this other recent thread?

    http://forums.us.dell.com/supportforums/board/message?board.id=dim_other&message.id=289604

    Sounds like you're having the same symptoms as the other poster and myself. As you see in the other thread, replacing my mobo didn't help. It was replacing the CPU that worked for me. It could actually be the mobo in your case as it has for some others from other threads, but in my case it was the CPU.

    As for point (1) in your post, the 4 LEDS (A, B, C, D) are on the back of your case. They should be right above where your keyboard and mouse connect. Judging by your symptoms, though, they probably aren't illuminating at all (just as in my case) and that may be why you can't see them.

    Message Edited by Katonk on 09-29-2006 12:22 PM

  • CaptRock

    16 Posts

    169

    0

    Posted September 29th, 2006 18:00

    I read EVERY message regarding the problem many have had/are having, with their 8400. I've tried EVERY remedy suggested by the those who chose to leave them (thanks!), but my problem continues. After pressing the power button, which shines a steady amber, the fan leading from the heat sink/blower assembly just accelerates like a "jet engine," as described by some posters.
     
    (1) First and foremost, I can't locate those four lights nearly everyone is referring to in their posts.
     
    (2) This steady amber power light is suppose to be an indication of a memory module problem (I have two 1GB DDR2 PC2 modules - slots 1&3) . As suggested, I removed/reinstalled the memory modules, then removed/reinstalled cards (PCI Express X16, modem). The problem remains.
     
    (3) I've detached/reattached HD, CDRW, DVD, and floppy drive. I've cleared the CMOS and reset NVRam. The problem remains.
     
    (4) The only "bright" point to all this is that the standby power light is illuminated. I take it that is a good thing.
     
    After all of this, it might be safe to say that my motherboard is shot! If anyone can be of any further assistance, please speak (type) up.  
     
     
  • CaptRock

    16 Posts

    169

    0

    Posted October 8th, 2006 11:00

    Katnok;
     
    Unlike most, it seems that replacing your CPU, rather than mobo, worked for you. It also appears that everything went well with that replacement. Any advice, pointers, recommendations you could give regarding your experience with replacing the CPU would be appreciated.