I recently installed a pair of cisco MDS 9124 to replace 2 old brocade switches.
To connect the mds's to the old brocades i had to set interop mode 3 on Cisco switches. Everything went fine and now i am left with a pair of working mds's set to interop mode 3.
I know that if i want to change it back to native mode i would have to put it offline briefly but cannot afford it right now because there are some hosts with a single path.
What are the limitations of having a vsan in interop mode 3? Will NPV work?
NPIV , the question is whether we will be able to connect a cisco fabric interconnect (operating in end host mode/NPV) later to this san without having to change interop mode on the switch we have now in production.
i have a test switch in the lab where i can try enabling interop and then try to enable NPIV ..not sure that will prove if i can use an NPV device after that. Would that help ?
i have a new set of FI going into place but that will be in a couple of weeks ...i'll ping you then and if you are still researching we can test it in my lab.
I strongly suspect that SAN running interop mode 3 would be able to support a connection to a switch port running in NPIV mode since that switch port should appear as a device port. Additionally, after looking at the Cisco documentation on interop mode 3 and interop mode 2, all of the changes appear to be fabric config type changes to enable E-port (or ISL type connectivity) between the two different switches. Since the NPIV enabled port should appear as a end device, those config changes shouldn't matter. The only caveat I can see if if NPIV cannot be enabled on the switch/port running in interop mode 3 but it appears you are already looking at testing that bit. Sorry but this is a long-winded way of saying I think the test would be valid.
dynamox
11 Legend
•
20419 Posts
•
87439 Points
1054
0
Posted December 18th, 2013 03:00
NPV or NPIV ?