SAN Copy Enabler installaion fails with USM and NST
Hi
I am having clarion AX4 5i and I am trying to to install the SAN copy enabler "SANCopyOption-01.23.5.001-xpfree.ena" but I am getting the attached error message .
To install the SAN Copy enabler you have to also upgrade to the full Navisphere Manager by adding the Navisphere Manager enabler and the Expansion Pack enabler. You can find the procedure at EMC CLARiiON AX4-5 support
Was your question answered correctly? If so, please remember to mark your question Answered when you get the correct answer and award points to the person providing the answer. This helps others searching for a similar issue.
Hi,i have the same problem.And when i install the ExpansionTier_enabler-01.01.5.001.ena in AX4-5SC,but i got the error message"it 's not support by this storage:Expansion",pls have a check!Thank You!
I had installed the NavisphereManagerAXEnabler,Now i want to install MirrorView_Enabler and Expansion_Tier,But it tell me the storage is not support to install the Expansion_Tier. So Why?
That's correct, the "SC" (single-controller) series only supports a maximum of 12 disks. You would have to upgrade it to a dual-controller configuration to obtain support for more DAE's/Drives that the expansion tier enabler offers to the non-SC models.
Jen_LeClair
111 Posts
3875
0
Posted September 12th, 2013 10:00
To install the SAN Copy enabler you have to also upgrade to the full Navisphere Manager by adding the Navisphere Manager enabler and the Expansion Pack enabler. You can find the procedure at EMC CLARiiON AX4-5 support