Nice thank you... whrere did you found that list?

Regards

From the

EMC Unisphere Remote

2.0.0

Installation Guide

P/N 300-013-602

REV A02

Note: Verify that ports 80/443 are open prior to installation. The GUI client

communicates with the Unisphere Remote server using these ports. VNX and VNXe

systems and the Unisphere Remote server communicate with each other using these

ports.

The following table lists IP ports used by VNX Family Monitoring and Reporting to access arrays. These ports need to be opened from Monitoring and Reporting to VNX and VNXe arrays.

For more information about monitoring VNX, you can read the document of VNX Family Monitoring and Reporting. If my answer is helpful, please help with marking it. Thank you!

Hi Sebbo,

The list is from the document of Security Configuration Guide on VNX for Block, page 15.

The ports used by the various components to pass data back and forth are an important aspect of Unisphere communication. You must understand which network ports are required by the various Unisphere components.Table below lists the unisphere components and ports that are used for communication: