UNSOLVED
Dell N2048P and Copper RJ-45 30m Transceiver Module
Hello,
Installed new transceivers (FS Dell GP-10GSFP-T Compatible 10GBASE-T SFP+ Copper RJ-45 30m Transceiver Module) to connect two N2048s with Cat6 and uplink tested good. Less than a week later, uplink went down and log on the uplink switch shows "INFO Invalid Transceiver present in the 0/49 (slot/port).compliance: 0x0"
Is there port settings or firmware version recommended? Any ideas?
Thanks
Thank you for sharing your experience.
Could you please clarify the current status of your setup? Did replacing the faulty transceivers resolve the issue permanently?
Also, could you share the exact Dell part number (P/N) of the 10GBASE-T RJ-45 SFP+ transceivers that are currently working with your N2048P switches?
DELL-Joey C
Moderator
•
4170 Posts
•
20965 Points
633
0
Posted March 8th, 2022 00:00
Hi @Tadman23,
It may seem to be a incompatibility of the SFP, but I'm still unsure of it yet.
Have you updated the switch firmware to the latest? I tried looking at the listed SFP for N2048P, the only copper transceiver available for this switch is only DPN# XTY28 which is Finisar FCLF8521P2BTL-DL.
DELL-Joey C
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’ if I did.