Hi guys I need help and advice how to fix my Alienware Aurora R14.
I installed new rams which were Hyperfury 3600 (64 gb)
Games ran fine after install. Didn't have any issue until I use Ryzen Master software to auto overclock.
After testing which took 45 minutes. I was able to apply the settings but afterwards it started to restart on its own.
I gotta admit. The first restart took me to Recovery Assist but I didn't want to system restore and lose my data so I left the screen and continued. It continued to restart after that.
I switched my old ram sticks back and also did the CMOS battery reset. When I did this it took me back to "memory ram changed do you want to enter bios.. etc"
Usually when this happens it would bring me back to Windows without any problem, and it actually did for about 10 seconds then it decided to continue restarting again.
So I decided to turn it off again and take out the CMOS battery... waited a few minutes. Once I finally turned it back on again. The PC would turn on but the display stopped showing.
Also during the restarts when it was still displaying. I couldn't access F2 = BIOS nor F12 Recovery.
Do you guys have any times how to fix this issue?
Also I'm off the warranty but I can renew anytime. Do you folks know if it's a good idea to renew the warranty and if Dell can possibly repair my PC or do RMA?
hi, so I was able to start my computer with one memory stick on but a bug 15 seconds after windows login my PC restarts again. Should I just system reset?
Also when I got to system recovery, there were no hardware errors.
Vanadiel
8 Professor
•
7094 Posts
•
29695 Points
0
0
Posted September 12th, 2023 21:28
Take RAM out, put back in the correct slots, and take out the CMOS battery again like you did before.
Remove all external devices besides keyboard, mouse and a single display.
Then try entering BIOS using F2 on first power on.
The restart is likely a BSOD, and it's set to automatically restart so you keep getting into and endless loop.