UNSOLVED
P
paulleverett
2 Posts
0
1724
May 3rd, 2010 11:00
Active session on a pool's device
I'm trying to unbind a thin device from a pool using SMC but getting the error message "The request device has active sessions, aborting...".
How can I find what the active sessions are so that I can clear them to unbind the device? My end goal is to delete the pool.
Thanks.
Following is the restriction.
You cannot unbound device if one of them occur.
◆ Device is mapped to a front-end port or in the Ready state
◆ Device is masked by VCM
◆ Device has active snap sessions
◆ Device is held
◆ Device is a source or target of a clone (src or tgt) session
◆ Device is a metamember
◆ Device is a part of enabled RDF CG group
◆ Device is an RDF devicepaulleverett
2 Posts
774
0
Posted May 3rd, 2010 13:00
Yes, there's one thin device associated with the pool. That's the one I'm trying but unable to unbind.
umichklewis
4 Apprentice
•
1190 Posts
774
0
Posted November 19th, 2013 06:00
As dynamox said, check to see if you have any clone sessions against the device. You can also symdev -sid 1234 list -held to show any devices that are being held. Again, chances are the device is in a clone session or is part of an SRDF group.
Let us know if that helps!
Karl
Boom1
131 Posts
774
0
Posted May 3rd, 2010 12:00
Welcome to community....
is there any thin device associated with pool?