UNSOLVED

PAPutzback

updated

20 years ago

0

4014

April 20th, 2007 15:00

GX240 - Hard drive not found. But XP finds it

At first I booted the system with an XP disc but when it came to format the drive it flashed from zero to 100 and said no disc could be found but it let me set the partitions up.
 
So I checked the drive and moved the jumpers from cable select to master and put it back on the end of the cable. At boot up the Bios stills tells me the hard drive is not found or unknown device for the primary adapter. I think it is the latter. Anyways this time XP formatted the drive and even started copying the files. I came back to check the system and it was back at the bios screen.
 
FRom reading the forums it appears I need to have the drive on cable select. But I already know that step won't even allow me to format.
 
Any help.
  • mombodog

    2 Intern

    •

    12735 Posts

    112

    0

    Posted May 1st, 2007 01:00

    Set to cable select, this is a must on a Dell, then
     

    If the computer generates a drive error message the first time you boot your computer after you install an IDE drive, your drive may not work with the automatic drive-type detect feature. Press in any hard drive field to set the hard drive autoconfiguration feature.

    During POST the computer scans the IDE channels for supported devices and generates a summary message. For example, if it finds that a hard drive is connected to the Primary channel and a CD drive is connected to the Secondary channel, it generates the following message:

    Performing automatic IDE configuration...

    Primary Master: IDE Disk Drive

    Secondary Master: CD-ROM Reader

    If it detects a device during the scan, it sets the device to Auto in system setup. If no device is listed, it sets the device setting to Off in system setup.

    If your computer does not reset after you perform these steps, enter system setup and reset the computer to its original Dell settings.

    1. Restart your computer.

    2. As the system reboots, press to enter system setup.

    3. When the system setup screen appears, press to load the Dell default settings.

    The computer beeps when the settings are restored.

    NOTE: Verify that the time, date, and year are correct and that the Secondary Drive 0 option is set to Auto.
    1. Press and then press to save your changes and exit.

    The computer reboots.

    Found here  http://support.dell.com/support/edocs/systems/opgx240/en/ug/advfeat.htm#1101811  under the heading "If you have a problem"

     

    If this fails to show the drive in the bios, suspect a bad IDE cable. Also flash the bios to the latest version if you have not done this already