UNSOLVED
A
ambientset
4 Posts
0
1771
November 9th, 2009 21:00
Dell 3000 problem
Hi!
The problem is that:
The printer quickly spends the CYAN TONER, the toner most part pours out in the printer. Having replaced a toner cartridge from f DELL, the printer of 10 minutes did calibration, and has then shown to replace the BLUE TONER. Has opened the printer, and inside all in the CYAN TONER.
Has cleaned the printer, has put a new toner - all has repeated!
Please, explain the reason?
ambientset
4 Posts
351
0
Posted November 13th, 2009 21:00
Thanks for the answer. But where to take this cleaning roll, to clean a laser glass
ambientset
4 Posts
351
0
Posted November 13th, 2009 22:00
Prompt please where I can buy this most developer?
ambientset
4 Posts
351
0
Posted November 13th, 2009 22:00
The such could occur, if I cleaned all mechanisms of the printer a vacuum cleaner?
kayser
104 Posts
351
0
Posted November 10th, 2009 03:00
Hello,
maybe you have a developer cyan issue and it's spending cyan toner, also about calibrating issue you could use cleaning roll to clean laser glass. You could locate a plastic blue trigger at the front of printer, then a small hole at right side of the printer will be open and you could see a blue piece that you should use about 15-20 times in and out to clean glass.
Hope it helps