Beginner VLAN help to connect two switches and routers
I need some help setting up two dell switches. I've not had any experience of setting up VLAN's on switches before so a bit of help would be great.
At the moment we have one Dell PowerConnect 2748 switch on the ground floor for data, connected to a router for internet access. Also we have a separate basic netgear switch for the IP Phones connected to another router for all voice traffic.
We're expanding to the office on the first floor and have purchased another Dell PowerConnect 2824 switch. The two floors are linked together by fibre. At the moment I've set the switches to managed mode so I can access the web interface from the network. I've installed the fibre cable so the two switches are linked together and working using ports 48 and 24.
I now need help setting up two VLANs so that the 1st floor switch has ports 2-12 for data and 13-22 for voice. And the Ground floor switch with ports 2-24 for data and 25-46 for voice. Then I can get rid of the old netgear switch too.
I've followed some basic instructions and set up VLAN membership, but VLAN 1 is still showing all the ports as U. I can't get the phones to pick up their IP range.
the PVID setting determines which vlan untagged received packets are classified to. Set the value on each port to the same value you have set on the VLAN Membership page. (I am assuming you have a simple setup of one untagged vlan per port).
The problem is that when I click the vlan 1 I am unable to change the U and T settings. I've set up vlan 2 on both routers so half the ports are U except for the final port I have set to T.
I can't seem to change vlan 1. What settings would I use for the vlan port settings? I've read the documentation, but can't follow it. I'm very new at this.
vlan 1 is the default vlan. Once you put a port in a different vlan and change the PVID for that port, the port will no longer be in vlan 1. vlan 1 cannot be tagged, so the vlan membership page will only show a "U" or a for vlan 1.
I've tried attaching another fibre connection, so I can have two separate VLAN's. But now when I set the Port Settings for each VLAN, the two switches can't ping each other, so one floor loses connection?
remove one of the fiber connections so that the 2748 and 2824 only have a single connection between them.
Assuming port 24 on the 2824 and port 48 on the 2748 are connected: port 24 (2824) AND on port 48 (2748), on the VLAN Membership pages, set vlans 2 AND 3 to 'T".
This will 'Trunk' the ports so that they both carry vlan 2 and 3 as tagged traffic. This will allow the vlan 2 and vlan 3 ports on each switch to talk to eachother.
bh1633
909 Posts
1941
0
Posted October 4th, 2010 10:00
did you change the PVID on the ports? It is on the Switch>VLAN>Port Settings page.