
UNSOLVED
Responses (7)
Solutions (0)
ManyDimensions
1318 Posts
260
0
Posted January 5th, 2007 21:00
Just a little bit extra to an already very good response....Normally, most ATX Dell cases have front mounted sound and USB ports. There is a small controller mounted to the front of the chassis behind the bezel where the LED status lights are found. This is behind the power button and hard drive activity indicator.Typically, a small ribbon cable connects the sound and front USB ports to this controller board and another small ribbon cable connects the controller board to the motherboard. This is not always the case on every Dell, as previously mentioned. Sometimes the status LED board and front ports are connected to the motherboard by two separate ribbon cables.I have experienced a few power on button failures in the past. Normally the power button switch has gone bad, not a connection.- thanks for the reply but i already looked in the manual prior to posting couldn't find anything at all, then i started looking at the markings on the motherboard to see if it was manufactured by another company so i may be able to get specs on the specific board. No luck their. My problem is the power button and the led cable has been removed from the mother board all together. The person that owned it before me needed the cable so he took it. I can't find anything telling me which jumpers to jump off to get the board to power up, all seems well with the board so i'd really hate to replace it just because i can't figure out which jumpers turn it on. If anyone knows that would be greatly appreciated. As for looking with a mag. glass, tried that prior to posting with no luck. I may have overlooked something so i'll keep looking but didn't find anything. If anyone has a dimension 2400 please tell me how the control panel connector is attached and i'd be forever thankful.. Thanks alot as always all responses are greatly appreciated.
- Ok, here goes nothing. As per the manual for a Dell Dimension 2400, the control panel connector is just below the three connectors for the floppy and the hard drive. It runs the same direction as the previous mentioned connectors and is about half the size of the IDE connections. For a more detailed look, go to this address for the manual.The ribbon cable connection is made so that it can only be pushed on the pins one way, so don't try to force it, just turn it 180 degrees and try again. Good luck.
- thanks alot thats still not what im looking for i need to know what two jumpers make contact on the board to power it up.. my control panel connector cable was stolen out my case. So i have no cable. Thats why i need to know which to jumpers to jump off in the control panel connector to make the board power up. If anyone knows that would be great. Thanks for any input.
- Ok, if you're trying to make a short cut by making your own cable, can't help you, it really is up to the motherboard. So I wouldn't make any recommendation at this point for fear of doing further damage to your pc. Couldn't you just order another cable. It will probably only cost under 10 bucks...
ManyDimensions
1318 Posts
260
0
Posted January 9th, 2007 22:00
Unfortunately you need the cable that was allegedly stolen from your computer.Finding that cable from Dell resources may be a bit tricky, but possible.I would look on eBay for an empty case that contains all the parts you need.

mdchuck61
7 Posts
260
0
Posted January 5th, 2007 21:00