
解決済み!
解決策へ移動PowerScaleの1ノード障害時のデータの動きについて
お世話になっております。
PowerScale A310などで、4ノード構成 2d:1nの構成のとき、
仮に1ノードが完全にアクセスできなくなってしまった場合、
その1ノード分のデータが正常な3ノードに分散されて
すべてリビルドされるような動きになりますでしょうか?
もしそうであれば、3ノードの状態でリビルドが完了した場合は
3ノードでも2d:nのポリシーを保って起動するイメージでしょうか?
以上、よろしくお願いいたします。
返信(2)
解決策(0)

ayas
Community Manager
•
7537 投稿
•
68231 ポイント
0
1
投稿済み 2026年5月11日 03:18
Pikkoroさん
PowerScale A310などで、4ノード構成 2d:1nの構成のとき、仮に1ノードが完全にアクセスできなくなってしまった場合、
その1ノード分のデータが正常な3ノードに分散されてすべてリビルドされるような動きになりますでしょうか?
→Drive障害の場合とは異なり、Node障害の場合はリビルドは自動で走ることはありません。
リビルドを起動するには管理者からの任意の実行が必要になります。(Remove NodeをしてSmartFailする)
これはNode障害が一時的なもの、である可能性もあるためOneFSでの自動リビルドは行われない仕様となっているためです。
PowerScale OneFS 9.14.0.0 Web Administration Guide
Page 305
Because node loss is often a temporary issue, OneFS does not automatically start reprotecting data when a node fails or goes offline. If a node reboots, the file system does not need to be rebuilt because it remains intact during the temporary failure
OneFS Smartfail
Occasionally a device might fail before OneFS detects a problem. If a drive fails without being smartfailed, OneFS automatically starts rebuilding the data to available free space on the cluster. However, because a node might recover from a transient issue, if a node fails, OneFS does not start rebuilding data unless it is logically removed from the cluster.
もしそうであれば、3ノードの状態でリビルドが完了した場合は
3ノードでも2d:nのポリシーを保って起動するイメージでしょうか?
→管理者がSmartFailを実行しても残りの3Nodeへの十分なスペースがあればリビルドは可能です。しかし壊れたNodeの交換をしてからの実行のほうが効率的になります。
PowerScale OneFS 9.14.0.0 CLI Administration Guide
Page306
If you remove a failed node before adding a new node, data stored on the failed node must be rebuilt in the free space in the cluster. After the new node is added, OneFS distributes the data to the new node. It is more efficient to add a replacement node to the cluster before failing the old node because OneFS can immediately use the replacement node to rebuild the data stored on the failed node.