I successfully replaced two hard drives in a RAID 1 array, in which one HD had failed.  After the volume was rebuilt on one of the new drives, I moved that to the primary port (Port 0) & installed the second new drive on the seconday port (Port 2).  The volume was also rebuilt on that one.  However, upon each reboot I get error messages that say "Volume0" could not be installed, New disc drive may not work, etc.  In Device Manager there is an exclamation point in front of Volume0.  Things seem to be working OK but I'm wondering if I still need to do something else like reset the CMOS.  I did reflash the BIOS once since installing the FIRST new HD.  Do I need to reflash again after the SECOND one has been installed?