UNSOLVED

Larryboy

updated

23 years ago

L

Larryboy

2 Posts

0

3024

February 25th, 2004 14:00

2nd Hard drive -- Cable select vs. Master/Slave questions

I bought a Dell 2400 desktop a couple of months ago. It came with a 80 GB hard drive. I'm planning on adding a second 80 GB hard drive (Western Digital) to use for storing videos for editing and burning to DVD. I don't understand the difference between Cable select hookup and Master/Slave hookup.

Which one is better? What is the difference? The instructions that came with the WD hard drive have a diagram that supposedly indicates which setup your existing computer/hard drive is capable of. However, the diagram (2 rows of 5 small pins) does not match my existing hard drive configuration (2 rows of 4 small pins) -- Supposedly the placement of the 'shunt' (or whatever it's called) in this configuration identifies it as cable select or master/slave.

Can anyone help me out here with info or links to where I can figure this out?  Thanks.

 

 

  • shesagordie

    12 Elder

    •

    46017 Posts

    429

    0

    Posted February 25th, 2004 15:00

    Larryboy.

    Dell uses Cable Select on their IDE drives.

    http://support.dell.com/us/en/kb/document.asp?DN=FA1036724

    Bev.

  • JOKERSWILD

    2 Intern

    •

    1448 Posts

    429

    0

    Posted February 25th, 2004 18:00

     

    Message Edited by JOKERSWILD on 02-25-2004 02:43 PM

    Message Edited by JOKERSWILD on 02-26-2004 06:21 AM

  • Doogie-224

    191 Posts

    429

    0

    Posted February 26th, 2004 02:00

    Where do I look for the pin hole " If you see a ribbon cable with a pinhole through one wire,"  Doogie
  • TechniKal

    76 Posts

    429

    0

    Posted February 26th, 2004 02:00

    "Cable Select" cables will work just fine with Master/Slave configurations. There's no performance difference between M/S and CS, and CS is 'easier' if you want to swap devices around.  I'd try CS first and only go with M/S if CS didn't work for some reason.