UNSOLVED
Newbie to Networker: Having issues getting new tape drive to recognize
I had a failed drive and I got a replacement. I am using Legato Networker 7.4 SP3. How do you tell Networker to look for the new drive and make it usable. It still thinks it has the old drive with that device serial number. The hardware I am using is an HP LTO 3 driver inside of a HP MSL 6000 series tape library. Your help is appreciated. Thank you.
Or you could use the "Re-configured Library" option on the library. To do this
- Go to NMC -> Devices -> Libraries -> right click on the library and select "Re-configured Library"
- Un-check the replaced tape and click "Start configuration"
- Right click on the library again and select scan for all devices. on the pop-up window follow the wizard with all default options.
- Wait for the scan to complete, refer the logs to see this.
- then right click on the library and select "Re-configured Library"
- select the new drive and click on start configuration.
Here is useful video demonstration on re configuring library on NetWorker,
https://support.emc.com/media39833_How-to-Configure-Jukebox-via-Networker-Management-Console-GUI.exe
https://support.emc.com/media39829_How-to-Configure-Jukebox-using-Jbconfig.exe
Regards,
Prajith
bingo.1
1 Rookie
•
2430 Posts
644
0
Posted June 24th, 2014 22:00
What does "inquire" tell you? - It should return the current information.
To change the jukebox/device attributes, there is the 'jbedit' command. However, if you are not familiar with it, deleting the jukebox and device and re-detecting/re-configuring it would be the easiest procedure.