
UNSOLVED
E
ecocom_bobby9
2 Posts
0
403
February 10th, 2002 12:00
Dell Dimension with Win2K will not load
I have a Dell Dimension 3N4X80J with windows 2000 and a 100Gb HDD. It was working fine for about 60 days and then it would not load the OS anymore. It can up that it could not find the boot.ini. I rebooted off the install cd and went to the command prompt. When I dir the c: drive I say it could not read directory inumeration.
In the end I decided to wipe and reinstall Windows 2000 from the install cd. I wiped all partitions and ran fdisk /mbr in case it was a virus of some sort. When the install of 2000 goes on it works correctly through the keyborad selection etc. but after the next restart it restarts the collecting information cycle again and continues in this loop.
I have run the Dell Diagnostics and there were no errors on the HDD.
I then switched the HDD with a spare 13Gb I had. The windows 2000 install works perfectly. I put the 100Gb HDD back in and the same thing happens where the OS keeps looping through the collecting user information section.
I would suggest the system is OK but the Hard Disk is having some issues, yet no errors are reported.
Have you any ideas
In the end I decided to wipe and reinstall Windows 2000 from the install cd. I wiped all partitions and ran fdisk /mbr in case it was a virus of some sort. When the install of 2000 goes on it works correctly through the keyborad selection etc. but after the next restart it restarts the collecting information cycle again and continues in this loop.
I have run the Dell Diagnostics and there were no errors on the HDD.
I then switched the HDD with a spare 13Gb I had. The windows 2000 install works perfectly. I put the 100Gb HDD back in and the same thing happens where the OS keeps looping through the collecting user information section.
I would suggest the system is OK but the Hard Disk is having some issues, yet no errors are reported.
Have you any ideas
Responses (3)
Solutions (0)
FishyAmoretto
48 Posts
179
0
Posted February 10th, 2002 21:00
anyone?
ecocom_bobby9
2 Posts
179
0
Posted February 10th, 2002 23:00
The drives original partition was 1 NTFS partition as it shipped from Dell. The preferred partition would be 25Gb NTFS active Primary partition for Os and apps, 5Gb Fat32 Logical for Ghost images and the remainder as NTFS Logical in the same extended.
The 13Gb drive I used to test would allow any of these configurations but the 100Gb keeps looping.
I have finally completed the full barage of Dell diagmostic test without any errors. This unfortunatley does not help me at all.
Bob

sawaddi
2 Intern
•
611 Posts
179
0
Posted February 10th, 2002 13:00