I have a VNX5300 that I purchased over Ebay all disk are empty and when I connect to the console by to com1 with Putty I always get Storage System Failure- Contact your Service Representative. this is on SP B and from SP A I see like aaaAAaBBBbCCc..... and after I get an
INFORMATION POST Start
Errorcode 0X0000018F
ErrorDesc:
FRU: All System FRUs
Fault Status Code: 0x00
Device: BOOT PATH
Description: Data directory Boot Service Not Loaded Error!
Rev: 42.20
EndError
I have all the Utilities available for VNX Unisphere Service manager , client, VNX client, Launch VIA , EMC VNX Installation Assistant. but since I don't have the IP configured for both SP's I can't use them. I would like to reset the all thing to set the proper IP by the console but it's not working.
Anyone can help me with this it been more than a week I trying to figure out what to do to fix this an be able to connect to this device.
Here is the link to EMC VNX5100 and VNX5300 Series Storage Systems Disk and OE Matrix. You will need to confirm that your drives are on the list.If your drives are not then they will not work with your VNX5300.
DELL-Sam L
Community Manager
•
8150 Posts
•
34715 Points
1426
0
Posted November 12th, 2020 12:00
Hello Marc,
You need to have a minimum of 5 drives in your VNX5300. Here is a link to a KB that maybe of assistance as well. https://dell.to/32DXTcm
Also here is a link to a video as well. https://dell.to/3phzrqS