Hi,

Do you set Isolation?

Please read P.153 of the Administrator's Guide.

yes, i am set isolation,

but why another autostart software dont  reboot ?

no, the different domain and different server host

hi,expert,

   thank your reply me .

   my meaning , i have already configure two autostart software cluster  with different PC server. one domain test1 , another domain test2.

   so it dont relation between of two domain for physical.

  when i try to pull out wan cable ,   the domain test1, it is the resource group can switch to passive server , the server cannt reboot.

when i try to pull out wan cable , the domain test2, it is the resource group can switch to passive server , the server will reboot.

best regards

hi,expert, do you have msn ?

can i directly chat with you ?

Hi,

Your situation cannot be understood.

You are composing AutoStart of two sets.
Two sets and Isoration are set.
And, the cable is pulled out.
However, only one cluster is rebooted.

Is this recognition correct?

Hi,

Do another clusters participate in the same AutoStart domain?

Hi,

Is the IP setting in Isolation right?
For example, the IP to set here is router or Gateway.

hi, expert:

    i have read your another reply to another person,  i unstander my question,

    because of the domain test1 is three network cable ,

    siutation of the domain test1

    one wan cable

    two  crossover cable

    three crossver cable ,

    the customer require i do following

     one wan cable for corporation,

     two crossover cable for mirroring

     three crossover cable for heartbeat

    so i do ,

    i configure following. is the configure  right ?

   userage of  one wan cable   is  domain network , point to point

   userage of  two crossover cable is domain network , point to point

   userage of three crossover cable is domain network, point to point

  the result :

  i can pull  out wan cable , the resoure group can switch the passive sever , the active server dont reboot.

another domain test2 with another two physical PC server ,

the situation following :

one wan cable for corporation,

two crossover cable for mirrioning and hearbeat

three corssover cable is disable from windows,.

the result:

when i try to pull out wan cable , the resoure group switch to passive server , the active server is reboot.

i think so it is the question of reason,

best regards