create a bootable USB Drive. use HP Disk Storage Format Tool, Rufus, DDDP or DOS (if you know how) to create one. copy A08 BIOS File to the Flash Drive and update BIOS outside Windows. i'm surprised Dell Support didn't show you how to do that.

read more here:

What is BIOS and How to Update the BIOS on Your Dell System |

so your USB Drive has a FAT32 Format, Bootable and the File still doesn't work?

Thanks for that! So I created the Drive with Rofus, And boot into dos in legacy mode, However when im typing the Bios file name the line is coming back with it bad command or file name. I even changed the bios file to something simple such as (A04). Any ideas? Thanks! 

Correct, I actually just read I should have it formated as FAT since its only a 2gig drive. In dos if I give it the dir command I can see the file. I also read somewhere that I should us the cd command to change the directory? 

This is how im typing it: cd Alienware_Area_51_R2_A04

Ive also tried it without the cd command. 

the most important Part when doing Clear CMOS is holding Power On Button so your PC has 0 Power left. something makes your BIOS Chip not working properly. the Idea is to take every single Bit of Power from it away. leave the Jumper alone.

and you do exact the same when you try to Update as the last Time it went through?

maybe Boot into Windows and try to launch the EXE as Admin.

Ok,So it went though this time, Guess it had to be FAT instead of FAT 32. It went through everything and said it was succesful, However the BIOS did not take. Still showing at A03....... 

OK,Just did that. Removed the battery and moved the jumper pins to pin 1 and 2, moved the pins back to 2 and 3 and put the battery back in. Update goes to Reading Flash then the next line says 30 - Error: Problem opening file for reading. Press any key to reboot. 

I did rename the file A04 to help with finding the file, DOS didnt seem to find the whole Alienware_Area_51_R2_A04 in the directory. 

Edit: So in dos if I look up the directory it looks like it changed the bios file from Alienware_Area_51_R2_A04 to AlienW~1, When I type that in it finds and starts the update,Right after I press Y for yes it starts reading the files then goes to 30-Error: Problem opening file for reading

Yup tried that as well. lol The dell tech just called me back, He said he consulted with some "Engineers" and they said the mother board needs to be replaced. They are sending a tech out to replace the MB for me,I was just hoping to get this done so I dont need someone to come out and rip everything out... 

edit: I just posted a video of the process but looks like its under review before it can post. 

WTH is going on there?

alright. try again.

disconnect all Cables

pull the damn Battery

hold Power On Button for a Minute

then Boot again and try to Update