Solved!
Go to SolutionHP-UX host not visible in Navisphere 6.1.9
I am in the process of adding a HP-UX host to our Clariion and having a problem with Navisphere recognizing it. The zoning in the brocade switches has been completed but the WWN does not show up in "connectivity status" of Navisphere Mgr. Even if I try to add the WWN as "new", it wont let me click OK. It appears that the zoning is correct since I see a LUNZ in the ioscan of the host. I installed the Navisphere Agent on the host and modified the paths as documented and still nothing.
Since the Knowledge base has no matches for this(why do I bother with it), I figured I would throw it out to the gang.
Since the Knowledge base has no matches for this(why do I bother with it), I figured I would throw it out to the gang.
EKellerman
76 Posts
331
0
Posted March 7th, 2007 09:00
3. Run the ioscan ¿fn and insf ¿e commands on the HP-UX host to
scan new devices and create new device special files.
4. Install the Navisphere Host Agent and CLI software on the
HP-UX host according to the instructions in the EMC Navisphere
Host Agent and CLI for HP-UX Version 6.X Installation Guide (P/N
069001146).
5. After the Navisphere Host Agent is installed on the HP-UX host,
edit the /etc/Navisphere/agent.config file to enable or
disable Auto Trespass according to Table 4-1 on page 4-5 by
adding or commenting out the line OptionsSupported
AutoTrespass. Add the nomegapoll keyword as a new line at the
top of the agent.config file. Save the file, and restart the
Navisphere Host Agent by running /sbin/agent/init.d stop
followed by /sbin/init.d/agent start.
Note: You must ensure that AutoTrespass is set correctly in the
agent.config file, because the AutoTrespass setting in the
agent.config file will override any AutoTrespass Initiator Type set
manually in Navisphere Manager whenever the Navisphere Host Agent
is restarted.
Have you tried this already?