Hi,

Thanks so I was checking the channel and not the group, so it is enabled at the the SRDF group level.

Is the software compression feature included as part of the SRDF license or is it a seperate license?

Thanks,

Victor

Good question. All I can tell its not seperately licensed so it has to be part of either SRDF base or SRDF A license.

regards,

Saurabh

OK thanks. The symcfg -rdfg x list here shows a fixed value of 10 for LL (which it may do for >= 10) so if it was on it wouldn't have a noticable performance difference I guess or else you get your metrics somewhere else...

That's answered my initial question how to check for it and I have looked up how to set it.  I need to research where to get metrics to help determine when it should be on as it is not on by default.

Thanks for you help

Victor

Hi,

With Vmax, the RDF compression should be controlled via solutions enabler. The new hardware and code supports both hardware and software compression.

To enable hardware compression you must use following command:

set rdf group x rdf_hw_compression=Enable

To enable software compression you must use again SYMCLI to define the SWCP policy (Sync/SRDFA/Adaptive compression).

Zikas:

I'm just about to do this on our VMAX.  Questions:

1.  So, I guess the RDFG has to already exist (that would make sense).

2.  Is this an online operation?  I can do it right in the middle of the day?  I don't have to suspend the group or take it out of "async/consistent" status?

3.  I only have to do it on the "send" end?

     Stuart

Hello Stuart and Happy New Year,

1. RDFG group must be already existed.

2. You can do this online on the software group (device group) but at the customer that i have done it, is using SRDF/S and i suspended the group just for "the fear of punishment".

3. Yes

John

Hi Stuart,

i am glad to help you.

I wish you good luck, but don't worry, everything will go fine.

It is straight forward job.

In any case, more or less, i am checking my email very often (Greek local time now is 16:46), so i have an eye on my email during the weekend.

John

John:

thanks for quick reply!

FYI, I just did a test case online during the day with no problem.  You don't have to suspend async.  It worked just fine.

I'm going to do the "big" change this weekend with production RDFGs.

   Stuart