I swapped out the memory; so far so good; no errors...Not sure why the iDRAC update failed (1.41 to 2.90). Should I install the BIOS update first and then try iDRAC update again? Thanks for your help!
After swapping the A2 memory module to A1 and A1 module to A2, I've just started getting the same error on A2. Does it mean I need to replace the system board? Can I instead move the two modules to A3 and A4?
After I got this error the second time after swapping out the modules, I cleared the logs. Ever since then, I haven't seen the error message again since September 2nd. I am going to continue to monitor to see if that has resolved the issue or not.
I had another question about updating the iDRAC and BIOS. When I tried updating the iDRAC, I got an error message. Is there an order in which the updates need to be done. Should I install the BIOS update first before doing the iDRAC? I am asking because I tried to do iDRAC first last time around.
BrainPOP
1 Rookie
•
8 Posts
4737
0
Posted August 31st, 2017 14:00
T610 ...and BIOS is 2.0.13