Here is my environment:
We have an EMC Celerra NAS NS502G sitting in a Colocation facility. It is hosting CIFS servers that need to be backed up. In this same colo facility we have several Windows 2003 Servers hosting files.
20 miles away we have our office where our IT staff works and this is also the location of our Network 7.22 server and backup drive.
The office is connected to the colo via a 300Mbs metronet circuit.
Before we moved any data from the Windows 2003 servers to the NAS, we were backing up data from the Windows 2k3 servers to the Networker server across the metronet at a rate of approximately 100GB/hour. Now that we are going from the NAS to the Networker server via NDMP, it is backing up at approximately 25GB/hour.
We are backing up using the following command in the Remote field on the Networker client.
"nsrndmp_save -T dump -M"
The following variables are set:
HIST=y
UPDATE=y
DIRECT=y
The NDMP backup only utilizes 1 drive on our Networker server whereas the non-NDMP backups could use multiple drives at once, although I was told that was a caveat of NDMP.
I also have a fiber attached tape drive on the Celerra for DR purposes, and if I initiate a backup from the NAS directly to the locally attached tape drive via NDMP as well, the backup speeds will increase exponentially.
Are there any tweaks that can be done for NDMP backups such as mine?
I really don't see why you can't use multiple drive - caveat is on Celerra side where you can have only 4 steams per data mover.
The speed you get is not good. While I didn't do network based Celerra backups, I did with directly attached drives using tar/dump and VBB. Usually I would get 50-70MB/s (I had one drive per data mover). So, I'm quite sure Celerra is able to perform. Since you have network in between I would check first that network card settings are in sync between both sides (and ports on switch).
You will probably need EMC support (Celerra) on this as VBB requires a file (actually a file system) on each DM which is used by restore operation of that kind. Once Celerra is configured for VBB you can start enjoying block based backups which should make difference in performance and speed you see.
I did speak with a Celerra engineer and he swayed me away from using VBB as it is doing volume backups, and the majority of our restore requests are file level restores. So this probably wouldnt be the best solution for us.
While doing some testing, I found that each backup thread from the NAS backs up at around 7Mb/s. So if I have a backup session going from the NAS, it is backing up at around 24Gb/hour. However, if I start another backup from the NAS, it too will run at the same speed. I almost expected to see both jobs running at 12Gb/hour to total 24Gb/hour, but it didnt. It seemed as though each job was backing up at the same speed.
That just seems to confirm there is some type of configuration somewhere that is limiting each backup thread to only go a certain speed.
ble1
6 Operator
•
14354 Posts
•
56186 Points
927
0
Posted April 23rd, 2007 08:00
The speed you get is not good. While I didn't do network based Celerra backups, I did with directly attached drives using tar/dump and VBB. Usually I would get 50-70MB/s (I had one drive per data mover). So, I'm quite sure Celerra is able to perform. Since you have network in between I would check first that network card settings are in sync between both sides (and ports on switch).