NON RÉSOLU

Camille BOSSA

a mis à jour

il y a 2 mois

CB

Camille BOSSA

1 Rookie

•

1 Message

•

2 Points

0

73

22 septembre 2026 11:30

PowerVault ME4024 - RAID5 disk group stuck in quarantine after dual disk failure - recovery possible?

Hi everyone,

We run a Dell EMC PowerVault ME4024 <To protect you, your private information was removed from public view. All private data was saved to your private Case. DELL-Admin>, firmware GT280R009-02) in production, hosting VMware ESXi datastores. After a controller restart, we're now dealing with two separate issues and would really appreciate input from anyone who has faced something similar.

Issue 1 - RAID5 disk group in quarantine
The disk group "DataStore_SAS01" (Pool A, RAID5, 12 disks) went into "Défaillance" (Critical) status with 0B available. Two disks (slots 0.19 and 0.20) failed simultaneously and no longer appear in the disk list. The group detail shows:

Cause: The disk group is in quarantine.
Recommendation: Search the event log for quarantine events (172, 485, or 590) and take the recommended action.

We already replaced the disk in slot 0.19 with a new (blank) disk, but the disk group is still shown as quarantined/0B, and the new disk doesn't appear at all in the "related disks" list.

Questions:
- Has anyone successfully cleared a disk group from quarantine after this kind of dual-disk failure, and recovered the original data?
- Does inserting a brand-new (blank) disk instead of the original removed disk break the standard quarantine-recovery path?
- Is there a safe way to check event codes 172/485/590 specifically (we can only find hardware status, not a searchable historical event log, in PowerVault Manager)?

Issue 2 - Expansion enclosure showing multiple disk failures
Separately, our expansion enclosure (Enclosure 1, 12 SSD disks, Pool B) shows around 9-11 disks in "Défaillance/Avertissement" status simultaneously, and the System table shows all 4 expansion ports (Module A ports B/C, Module B ports B/C) as "Déconnecté." We've physically checked the SAS cables and they appear properly seated.

Has anyone seen this pattern before (many disks failing at once + all expansion ports down)? Could this point to something other than a cabling issue - e.g. an EMM (expansion module) failure?

We don't currently have an active Dell support contract, so any community insight while we wait to hear back from Dell sales/support would be hugely appreciated. 

Thanks in advance!

(modifié)

  • DELL-Sam L

    Community Manager

    •

    8147 Publications

    •

    34706 Points

    3

    0

    Publié 24 septembre 2026 08:35

    Hello Camille BOSSA,

    First things first, when you have a double disk error on the same disk group in most cases the data is gone. Now without looking at your logs and seeing what errors are happening it is hard to say if the data can be recovered. If your ME4024 still has an active support contract, I would contact support for assistance in this matter to ensure that they can review your support logs to see what is going on. If your ME4024 is not under any support contract then you will need to look at the majior event log to see which drive failed in which order. You can also look in the log to see what caused the expansion enclosure fail as well.