
UNSOLVED
Closed
N
neo_philiac
1 Rookie
•
11 Posts
0
16362
July 26th, 2006 14:00
memory
Is there any way I can disable the on board memory and use the additional memory that i bought for Isnpiron 1200 ? the built in memory is damaged and i need to use the add on memory for it to run.
Responses (9)
Solutions (0)
neo_philiac
1 Rookie
•
11 Posts
260
0
Posted July 26th, 2006 15:00
See here is the thing I opened the back for memory and there is no card but i can still see on the BIOS that i have 256 MB memory. When I run diagnostics it shows: Memory Check - Failed. So i bought one and now after putting it in, i get the same message. Can you tell me what problem I might be having?neo_philiac
1 Rookie
•
11 Posts
260
0
Posted July 26th, 2006 15:00
i cant take out the old memory . i cant find it on the motherboard . are you talking about inspiron 1200? cant you anyhow tell me where it is located?- No. Memory is not part of the motherboard. Remove the damaged memory chips and install the new memory---make sure it is the correct match. Sounds like the motherboard might be damaged, not the memory chips themselves. Run diagnostics on the computer or take it to a repair shop. Here are the instructions: http://support.dell.com/support/edocs/systems/ins2200/en/SM/upgrades.htm#1084976
Message Edited by Mary G on 07-26-200612:06 PM
neo_philiac
1 Rookie
•
11 Posts
260
0
Posted July 26th, 2006 21:00
I know. But when I goto BIOS setup without the card in it, I can see I have 256 MB as my memory. I bought 512 MB(Dell Certf.). When I put that in, I can see in the BIOS i have 768 MB. I know!! I have been troubleshooting hardware for 5 years but never encountered this kinda problem. I am guessing BAD motherboard.The Inspiron 1200 comes with 256 MB of FIXED ram built onto the motherboard that cannot be removed/replaced . It has one additional socket for upgrading the memory .
It maybe possible to dsable the onboard Ram through the BIOS and install the 512 MB module u just bought . Will do a bit of searching and update ..
neo_philiac
1 Rookie
•
11 Posts
260
0
Posted July 27th, 2006 11:00
Please do let me know. Thanks ...among all you are the only one who really knows about stuff. I am stuck and I really need to get this thing done.

toant103
98 Posts
260
0
Posted July 26th, 2006 14:00