UNSOLVED

mykalli

updated

22 years ago

M

mykalli

1 Message

0

10733

October 29th, 2004 17:00

No Subwoofer! (Audigy2 / ADA885)

I just got an Audigy 2 soundcard for gaming. I have the " Altec Lansing ADA885" speakers (4.1). I've had these THX speakers for awhile and really like them. I used to have a SoundBlaster Live Value card and all was well. Now with the new Audigy card I have no subwoofer at all. I've checked the boards and tried the various connection and settings options. Everything appears to be correct, except no subwoofer sound. I've heard that there may be a "phase" problem between some Creative products and specifically the ADA885 setup. My computer is a new Dell Dimension XPS Gen2. Dell posted a patch for this problem but it did not fix the problem. Any insight or assistance would be greatly appreciated.
  • golf1127

    1 Message

    971

    0

    Posted November 1st, 2004 16:00

    To Mykalli,

    I also have a audigy2 with the Altec-lansing ADA885 from my previous Dell system.  Told all would work fine between the 2, however I can't get any sound using the digital SPDIF (wrong letters here...I am sure).

    My sub-woofer works just fine, just I can't get dolby digital to work.  I tried just about every set-up config. I could think of.  Does anyone have a set-up for this combo that works?

    Thx...........

     

      

     

  • JgDMZ

    2 Posts

    971

    0

    Posted November 2nd, 2004 19:00

    Hi,

    Yes, I have the same problem too - no sound from the rear speakers.  I've tried all I can think of and have read about. We're not on our own - the Creative support site in Europe seems to show that there's a lot of users in a similar boat.

    For what it's worth, the best I can do is use Quad output on the ADA885s and Quadrophonic setup in Windows for the speakers.  This is all analogue sound though, and sounds poor when compared to what these speakers can do with digital.

    Gimme back my Turtle Beach Santa Cruz! :-)  Seriously - any advice would be *very* gratefully received.

    Thanks!

  • SI8300

    55 Posts

    971

    0

    Posted November 3rd, 2004 09:00

    don't you just change the setup from digital to analogue to get it to work?
  • JgDMZ

    2 Posts

    971

    0

    Posted November 3rd, 2004 18:00

    Not sure what you mean by just changing from analogue to digital.  I've tried changing the card settings to digital output, but this reverts to only front speakers working.  I have also tried changing speaker settings to Dolby Digital and this has the same effect.  Can you explain more?

    Thanks.

  • elliotgb

    22 Posts

    971

    0

    Posted January 4th, 2005 16:00

    You need to change your speaker configuration to 5.1. This will allow you to use the 4 satellite speakers and the subwoofer as the 5th. You need to get into the THX Setup console and set the speaker selection to analog and 5.1, then you should see subwoofer info on the speaker settings under bass management.

    I have a Audigy 2 ZS card with the ADA885 speaker system.

    I don't have a digital spdif connector anywhere on my system so I can never use the digital capabilities.