
UNSOLVED
Responses (2)
Solutions (0)
I found a way.
Now I didn't use the converter cable because I didn't realize there was one.
The cable may and may not work because dell switched the connection around on their motherboard. So the normal PWM pin arrangement of Power, Sense, PWM and Ground won't line up with dell's PWM, Power, Ground, Sense pins. I can only assume they did this so that if you got their five pin connector and hooked it up to a standard PWM fan and installed it, the fan still wouldn't work. If that cable switches the connections around then it'll work fine and be alot easier than cutting and soldering the wire. I cut the cable wires, rearranged them and soldered them. This rearranging the wireing amongst other things is why there is no software that can find let alone control the fans on this computer.
If you do use the cable I think you will still have to solder a normal male PWM fan connector onto your fan's wires. Maybe then you could even get an aftermarket PWM fan and install it.
I have full auto and full manual (full manual control really only takes the fans down to 25% but you can turn them up to 100% if necessary) control of both the CPU and the Card Fan.

Davet50
6 Operator
•
14442 Posts
242
0
Posted February 2nd, 2011 14:00
Nividia ntune did some what but it was buggy and cause more problems then it helped. This was the only program that would even allow you set them